Allied Telesis AT-TQ2403 User Manual page 270

270
add
factory-reset
get
reboot
remove
save-running
set

Example 2: Type "get " TAB TAB (including a space after get) to see a list of all property options
for the get command.
AT-TQ2403# get
access-point
ap-list
association
basic-rate
bridge-port
bss
channel-planner
cluster
config
detected-ap
dhcp-client
dot11
firmware-upgrade Upgrade firmware of the AP through http
host
interface
ip-route
log
log-entry
mac-acl
management
ntp
portal
radio
radius-user
serial
snmp
ssh
static-ip-route
supported-rate
system
telnet
traphost
tx-queue
untagged-vlan
vwn
web-server
wme-queue

Example 3: Type "get system v" TAB. This will result in completion with the only matching
property, "get system version". (Hit ENTER to get the output results of the command.)
AT-TQ2403# get system v
AT-TQ2403# get system version

Example 4: Type "set" TAB TAB (including a space after set) to get a list of all property options for
the set command.
AT-TQ2403# set
AT-TQ2403 - Management Software - User's Guide
Add an instance to the running configuration
Reset the system to factory defaults
Get property values of the running configuration
Reboot the system
Remove instances in the running configuration
Save the running configuration
Set property values of the running configuration
Guest, VLAN and VWN settings
AP list for rogue AP detection
Associated station
Basic rates of radios
Bridge ports of bridge interfaces
Basic Service Set of radios
Channel planner settings
Clustering-based configuration settings
Configuration settings
Detected access point
DHCP client settings
IEEE 802.11 (all radios)
Internet host settings
Network interface
IP route entry
Log settings
Log entry
MAC address access list item
Management communication configurations
Network Time Protocol client
Guest captive portal
Radio
RADIUS user
Serial access to the command line interface
SNMP (Simple Network Management Protocol)
SSH access to the command line interface
Static IP route entry - used when DHCP is off
Supported rates of radios
System settings
Telnet access to the command line interface
Destination host for SNMP trap
Transmission queue parameters
Untagged VLAN configuration
Virtual Wireless Network
Web server
Transmission queue parameters for stations