Page 1
To reduce the risk of injury, all operators and maintenance personnel must read and understand these instructions before operating, changing accessories, or performing maintenance on Masalta power equipment. All possible situations cannot be covered in these instructions. Care must be exercised...
ACCESSORIES CONTENTS Transport trolley – Fitted with 200mm rubber tyre. Introduction ………………………………………………………1 Applications...…………………………………….………………1 HAZARDS AND RISKS Functions and controls…………………….….………………...1 NEVER allow any person to operate the machine without Accessories………………………………………………………1 adequate instruction. Hazards and risks…………………………….……………….1-2 Operation ……………………………………….……………..2-3 ENSURE all operators read, understand and follow the Care and preventive maintenance…………….……………...
! FIRE & EXPLOSION HAZARDS not be used until the fault is rectified. PETROL is extremely flammable and explosive under certain Thoroughly inspect the compactor for signs of conditions. damage. Check components are present and secure. Pay special attention to the belt drive safety guard ENSURE that the petrol is only stored in an approved storage fitted between the engine and the vibrator unit.
Petrol Engine Increase the motor speed to the maximum setting using the Open the fuel tap by moving the fuel ON / OFF lever hand throttle lever, before commencing compacting. fully to the right. If starting the engine from cold, set the choke ON by The machine should be controlled by grasping the handle with moving the choke lever fully to the left.
Page 5
Daily Service CAUTION: Check for leakage of fuel or oil. Inspection other services should Remove soil and clean the bottom of compaction plate. always be carried out on hard and level Check engine oil. ground with the engine shutdown. Check for loose screws including tightness. See Table 3 below (tightening torque), for retightening.
Engage V-belt to lower vibrator pulley and push the V-belt to left side of upper clutch and, in the same manner as in removal, rotate offset wrench clockwise so that the V-belt REVERSIBLE SOIL PLATE MSH160-1 goes back on. Frequency (vpm):...
Working Size (L x W x H): TRANSPORTATION MSH160: 86 x 42 x 93 CM Always shut off engine when transporting machine. Make sure lifting device has enough capacity to hold machine (see identification plate on machine for weight). Use central lifting point (a) & (b) when lifting machine.
Page 9
MSH160 & MSH160E PARTS LIST 1 ITEM NO PART NO DESCRIPTION 3001000 BASE PLATE ASSEMBLY 3002000 VIBRATION BOX 0700018-45 BOLT M18 x 45-GB70 0970018 WASHER 18-GB97 0930018 SPRING WAHSER18-GB93 3003000 ENGINE MOUNTING PLATE 3004000 ADJUSTING PLATE 0410012 NUT12-GB41 0970012 WASHER 12-GB97.1...
Page 10
MSH160 & MSH160E PARTS LIST 2 ITEM NO PART NO DESCRIPTION 3001001 BASE PLATE 3001002 VIBRATION DAMPER 0970012 WASHER12-GB97 0617012 NUT M12-GB6170 3001003 EXTENSION PLATE (MSH160E ONLY) 0970020 WASHER-GB97 (MSH160E ONLY) 0930020 SPRING WASHER-GB93 (MSH160E ONLY) 0578020 BOLT M20X45-GB5783 (MSH160E ONLY)
Page 11
4 5 6 3 7 5 7 4 8 1 4 3 MSH160 & MSH160E PARTS LIST 3...
Page 12
MSH160 & MSH160E PARTS LIST 3 ITEM NO PART NO DESCRIPTION 3002001 EXCITER BOX 3002002 BOX COVER 0700008-25 BOLT M8 x 25-GB70 0930008 SPRING WASHER8-GB93 0119008 PIN BOLT8-GB119 0283006 BEARING32206-GB283 OIL SEAL ∮52 x ∮28 x 7-GB9877.1 0987752 3002003 BEARING COVER...
Page 13
MSH160 & MSH160E PARTS LIST 3 ITEM NO PART NO DESCRIPTION 3002014 SPINDLE 3002015 DIRECTION HOUSING 3002016 ROTARY COVER 3002017 WAHSER 0930005 SPRING WASHER5-GB93 0700005 BOLT M5 X 15-GB70 3002018 SPINDLE 3002019 BASE COVER 0345226 O RING25.8 X 2.65-GB3452.1 0578308...
Page 14
M S H 1 6 0 & M S H 1 6 0 E P A R T S L I S T 4 ITEM NO P A R T N O D E S C R I P T I O N Q T Y 0 27 6 00 8 BEARI NG16008-GB276...
Page 16
MSH160 & MSH160E PARTS LIST 5 ITEM NO PART NO DESCRIPTION 0578012 NUT M12 X 70 - GB5780 0950012 WASHER 12 -GB95 3006010 COLLAR 3006012 NYLON COLLAR 3006400 VIBRATION DAMPER 0578008-30 NUT M8 X 30 - GB5780 0950008 WASHER 8 - GB95...
Page 17
1 38 M S H 1 60 & M S H 1 6 0E P A R T S L IS T 6 ITEM NO P A R T N O D E S C R I P T I O N Q T Y CLU T CH C E NT R E F OR D IE S EL 3008001-1...
WARRANTY WARRANTY WARRANTY WARRANTY These products are covered by warranty for a period of six (6) months from the date of purchase against defects in material or workmanship provided that: · The product concerned has been operated and maintained in accordance with the operating instructions. ·...
Suixi Rd., Hefei 230041, China, certifions que si le produit décrit dans ce certificat est achet é chez un distributeur autorisé Masalta au sein de la CEE, il est conforme aus norme CEE ci-après: 98/37/CE (cette norme est une codification des normes de la machine d'origine 89/392/CEE), Norme compatible pour I'électromagnisme 89/336/CEE (modifié...
Need help?
Do you have a question about the MSH160 and is the answer not in the manual?
Questions and answers