Removing The Bottom Cover Of The Optional Tray; Removing The Stack Tray Paper Surface Detection Sensor; Removing The Tray Guide Top Cover; Removing The Stack Tray Assembly Harness - Canon Additional Finisher Tray-C1 Service Manual

[4]
3.4.1.2 Removing the Rear Cover of the Tray
1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2] of the tray.
[1] [2]
F-3-13
3.4.1.3 Removing the Stack Tray Assembly
1) Holding the stack tray [1], remove it in the direction of the arrow.

3.4.1.4 Removing the Bottom Cover of the Optional Tray

1) Remove the two P tightening screws (M4 x 12) [1], and then remove the
bottom cover [2] of the optional tray.
[3] [2] [1]
F-3-12
[1]
F-3-14
3.4.1.5 Removing the Stack Tray Paper Surface Detection
Sensor
0010-7683
1) Disconnect the connector [1], and then remove the stack tray paper surface
detection sensor [2].
3.4.2 Stack Tray Upper Limit Sensor
3.4.2.1 Removing the Stack Tray Assmbly Harnes
0010-7684
1) Remove the screw [1], and then remove the sensor mounting plate [2].
2) Remove the harness from the two wire saddles [3], and then remove the
reusable band [4].
0010-7685

3.4.2.2 Removing the Tray Guide Top Cover

1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
tray guide top cover [2].
[1]
[2]
F-3-15
[1] [2]
F-3-16
[4] [3] [2] [1]
F-3-17
Chapter 3
0010-7686
0010-7687
0010-7688
3-3