Using Your Phone's Battery - Sanyo Sprint SCP-7000 Operating Manual

Using Your Phone's Battery

Installing the Battery
Your phone comes with a Lithium Ion battery. Follow these steps to install it:
1. Insert the battery into the opening on the back of the phone and gently press down.
2. Place the battery cover into the position, and then slide it until you hear it snap into place.
Removing the Battery
To remove your battery, follow these easy steps:
1. Make sure the power is off so that you don't lose any stored numbers or messages. Press the
battery release latch, and then slide the battery cover and remove it.
2. Use your thumbnail to lift and then remove the battery.
Charging the Battery
Your phone comes with a rechargeable battery. You should charge the battery as soon as
possible so you can begin using your phone.
Keeping track of your battery's charge is important. If your battery level becomes too low, your
phone automatically turns off and you will lose all the information you were just working on.
For a quick check of your phone's battery level, glance at the battery charge indicator located in
the upper-right corner of your phone's display screen. If the battery charge gets too low, the
battery icon appears and the phone sounds a warning tone.
Always use a recommended Travel Charger or Vehicle Power Adapter to charge your battery.
Warning! Using the wrong battery charger could cause damage to your phone and void the
warranty.
Using the Travel Charger
To use the travel charger provided with your phone:
1. Plug the travel charger into a wall outlet.
2. Plug the other end of the travel charger into the bottom of your phone (with the battery
installed).
Charging when your phone is turned on:
The battery icon turns to
Charging when your phone is turned off:
The battery icon
shown on the display while charging. When the battery is completely discharged, you may
wait for several minutes until the message is shown on the display. The battery icon turns
to , and message changes to "CHARGING COMPLETE --Power Off--" when charging is
completed.
when charging is completed.
appears, and the message "BATTERY CHARGING --Power Off--" is
10