Activating The Default Ip Address; Assigning Ip Parameters - Phoenix Contact FL SWITCH GHS 12G/8 User Manual

FL SWITCH GHS
54
PHOENIX CONTACT
– PROFINET and Ethernet/IP are deactivated.
The aging time is set using the "dot1dTpAgingTime" MIB object (OID 1.3.6.1.2.1.17.4.2).
The available setting range is 10 to 825 seconds. For static configuration, an aging time of
300 seconds is recommended.
During switch restart, the active configuration including IP parameters is written to a
plugged-in configuration memory.
The GHS offers several user interfaces for accessing configuration and diagnostic data.
The preferred interfaces are the web interface, CLI, and SNMP interface. These interfaces
can be used to make all the necessary settings and request all information.
Access to the serial interface via Telnet/V.24 (RS-232) interface or SSH only enables
access to basic information.
The following generally applies: Settings are not automatically saved permanently. To
permanently save the active configuration, select "Save ..." in the relevant user interface.
4.2

Activating the default IP address

After the boot phase, proceed as follows using the buttons/display:
• Press "Menu".
• Select "IP Menu" and press "Select".
• Select "IP Settings" and press "Select".
• Select "Default IP" and press "Set".
The switch can now be accessed via IP address 192.168.0.100. Make any necessary
adjustments on your PC.
Please note:
– The selection of the default IP is not stored retentively. Save the desired configuration
via the management interfaces.
– Make sure that there is only one device with the IP address 192.168.0.100 in your
network.
4.3

Assigning IP parameters

As long as the "BootP" setting has not been changed, when the supply voltage is switched
on or the reset button is pressed, the switch sends requests (BootP requests) to assign
IP parameters.
The two buttons on the display must be held down together for a few seconds to trigger a
reset.
The "BootP" function is activated by default. If the switch has already been started up, the
"BootP" function can be deactivated via the management.
The assignment of valid IP parameters is vital to the management function of the switch.
If the switch has not been assigned valid IP parameters, "No IP assigned 01" will appear
in the display.
8016_en_02