The Answering Machine - Philips CD450 User Manual

RESTORING DEFAULT SETTINGS
You can reset your phone settings to the original factory settings.
1. Press .
2. Select A A A A dvanced set dvanced set
dvanced set dvanced set
confirmation request.
OK
3. Press to confirm. All settings have been reset.
NOTE: After reset, your handset's power switches off. It will switch back
on in a few seconds after updating all the settings. All handsets return
to the Welcome screen after reset.
To see a list of default setting, see Default (pre-programmed) settings on page 56.
The System
OK
Reset. Press Reset . The handset displays a
Reset Reset
- 47 -

The Answering Machine

Once switched on, your answering machine is ready to be used. By default, your
answering machine is set to Answer and Record mode. You can also access the
machine remotely.
7-SEGMENT DISPLAY
Your answering machine comes with a 7-segment display to show you the
number of messages you have and other visual messages about its operation.
-- Memory full 00
AA Remote access
Recording
SWITCHING THE ANSWERING MACHINE ON/OFF
From the base
1. Press during standby.
From the handset
1. Press .
2. Select A A A A ns machine ns machine ns machine ns machine
3. Select the new setting. Press
Once switched on, your answering machine will answer incoming calls after a
certain number of rings depending on the ring delay setting. See Setting the ring
delay on page 54.
The 2-digit number shows:
- The volume level, or
- The message number
(blink for new messages)
OK
A A A A ns ns ns nswer wer on/off wer wer on/off. Press on/off on/off .
OK
. The setting is saved.
- 48 -