Bebe style BCS222BLACK Instructions Manual

Car seat (groups i/ii/iii).suitable for 9kgs to 36kgs (approximately 9 months to 12 years).

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

INSTRUCTIONS

Car Seat (Groups I/II/III)

Suitable for 9kgs to 36kgs

(Approximately 9 months to 12 years)

ENGLISH

Table of Contents

Need help?

Do you have a question about the BCS222BLACK and is the answer not in the manual?

Questions and answers

Summary of Contents for Bebe style BCS222BLACK

Page 1 INSTRUCTIONS Car Seat (Groups I/II/III) Suitable for 9kgs to 36kgs (Approximately 9 months to 12 years) ENGLISH...
Page 2 WARNINGS THESE INSTRUCTIONS ARE VERY IMPORTANT. PLEASE READ THROUGH CAREFULLY, AND RETAIN FOR FUTURE REFERENCE. PLEASE READ THOROUGHLY BEFORE COMMENCING INSTALLATION, AS AN INCORRECT INSTALLATION COULD BE DANGEROUS. DO NOT USE THIS CAR SEAT IN PASSENGER SEATS EQUIPPED WITH AIRBAGS. This child seat can be used with the harness for children of 9 –...
Page 3 Luggage and other heavy or sharp objects should be secured in the car. Loose objects are liable to cause injury in the event of an accident. Periodically inspect the harness for wear, paying particular attention to attachment points, stitching, and adjusting devices. Store this child seat in a safe place when it is not being used.
Page 4 PARTS AND FITTINGS...
Page 5 Assembly Before Use To set up your car seat, remove all packaging and set down on a flat surface. Your child seat consists of two parts; the booster seat and backrest. Ensure both pieces are lying flat before assembly. Insert the two hooks located at the bottom of the backrest into the gaps found at the rear of the booster seat.
Page 6 CORRECT SHOULDER STRAP HEIGHT (GROUP I) CHANGING/ FITTING THE SHOULDER STRAPS - HEIGHT Thread the shoulder straps through shoulder pads, then through the shoulder slot at the front of the seat (1) (see above for correct heights). Push the straps right through the seat out at the back.
Page 7 REMOVING THE SAFTEY HARNESS LAP STRAPS (BOOSTER) Turn the metal connectors at the base of the seat on their narrowest end and feed them through the slots in the base of the seat, then through the slots in the fabric cover.
Page 8 TIGHTENING THE HARNESS Pull the shoulder straps upwards to remove the slack from the lap sections of the harness. Now pull the adjuster strap until the harness is fully tightened. The harness should be adjusted as tightly as possible without causing discomfort to your child.
Page 9 FORWARD FACING FITTING THE CAR SEAT WITH THE 3 – POINT LAP & DIAGONAL SEAT BELT 9-18KGS (GROUP I) Ensure that all parts are locked into place correctly and not trapped in the seats or doors. The backrest of the child’s seat has to rest on the back of the vehicle seat.
Page 10 2. Thread the seat belt through the fabric seat belt slot – marked by a red arrow under the cushion insert, and the lap strap under the ‘arm’ of the booster. 3. Pass the seat belt through the back of the seat (underneath the harness straps), and through the...
Page 11 4. Hook the seatbelt over the parallel ‘arm’ of the booster seat, and click the seat belt in place. 5. Tighten the seatbelts until the car seat feels secure Now you can strap your child into the seat. Make sure the seat belt has not become twisted.
Page 12 ADJUSTING THE HEADREST HIGHT 15-25KG (GROUP II) (According to the child’s height) The headrest can be adjusted up or down. Press the button in, and. Move the headrest up or down as required ensuring the position fits for your child FORWARD FACING FITTING THE CAR SEAT USING THE BELT GUIDE (GROUP II) IMPORTANT: Before fitting the seat, remove the shoulder straps, buckle and...
Page 13 Place the child in the child safety seat. Fasten the seat belt, making sure that both sections of the seat belt go under the armrests, the diagonal belt goes through the belt guide on the side of the headrest, as shown above. Check that the seat belt has not become twisted, and tighten the seat belt by pulling the diagonal strap upwards.
Page 14 Place the booster seat on the seat of the vehicle ensuring it is firmly against the vehicle seat and backrest. Place child on the booster seat. Fasten the seat belt, making sure that the lap belt goes under both armrests and the diagonal belt goes under the armrest near the buckle.
Page 15 CARE AND MAINTANANCE THESE INSTRUCTIONS ARE IMPORTANT, PLEASE READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE. Backrest cover removal: First release the strap at the bottom of the backrest cover. Slide the cover off. The cover can now be cleaned. Headrest, booster seat cover removal: Slide the cover off. The cover can now be cleaned.
Page 16 1. This is a “Universal” child restraint; it is approved to ECE Regulation 44.04 for general use in vehicles and will fit most, but not all vehicle seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a “Universal”...

This manual is also suitable for:

Cs212blue Bcs222grey Bcs222red Bcs222pink