Kenwood CHEF KM010 Series Instructions For Repair

INSTRUCTIONS FOR REPAIRING THE KENWOOD CHEF KM010 & KM020 SERIES
THESE INSTRUCTIONS ARE FOR THE KM10 & 020 SERIES MIXERS
ONLY - NOT THE A901, A901E or KM200 Series

YOU WILL NEED -

SOLDERING IRON AND SOLDER
DE-SOLDERING PUMP OR DESOLDERING WICK.
CUTTERS
T20 TORX DRIVER
PLIERS
TURN OFF THE POWER AND UNPLUG THE MIXER
PRESS THE BUTTON ON THE SIDE AND RAISE THE MIXING HEAD.
LAY MIXER ON ITS 'BACK'.
REMOVE THE 2 TORX SCREWS IN PHOTO ABOVE.
PRESS THE BUTTON ON THE SIDE AND PUSH THE SILVER ARM AND
ITS BRACKET DOWN INTO THE BASE.
PULL COVER DOWN FROM THE FRONT (BACK IS HOOKED UNDER THE HINGE)
PUSH COVER INTO THE BASE, EXPOSING THE CONTROLLER AND THE MOTOR.
UNPLUG THE CONNECTORS FROM THE SPEED CONTROLLER UNIT (NOTING
WHERE THEY CAME FROM AND WHICH WAY ROUND THEY ARE FITTED).
PULL THE SPEED CONTROLLER UNIT FROM ITS SLOT IN THE MIXER BODY
UNCLIP THE COVER FROM THE BACK OF THE CONTROLLER UNIT,
THE CIRCUIT BOARD AND ITS COMPONENTS WILL NOW BE EXPOSED.

BEFORE YOU DO ANYTHING -

VIEW OF THE CIRCUIT BOARD
COVER
SILVER ARM
2 T20 TORX FIXING SCREWS