Siemens 5WG1 258-2EB22 Technical Product Information page 9

Mounting / Dismounting the shade
Put the shade H2 over the lens of the device H1and fix it with the design ring H3.
Note:
The programming button be reached only partly when the shade is mounted.
Mounting the design rings
The design ring H3 is clipped on to the device H1 from below, until
the snaplock hooks on the design cover engage on the outer edge
of the device with an audible click.
Dismounting the design ring
The design ring is dismounted by pulling downwards. Use a
screwdriver to help with this operation.
Caution:
·
Be careful when handling the screwdriver. There is a risk of
scratching the ceiling or the design cover. Accordingly, be
gentle while working
Commissioning / Factory default
After the device is connected to the bus voltage, the sensor must first "Restart", i.e. the motion sensor will
be initialized.
Factory default
In the delivered state, the parameter Operating Mode is set to setting mode.
While the device is in "Setting Mode", the integrated programming LED displays the PIR sensor state.
(flashes briefly with motion).
The programming mode can be set in factory default status also with the available IR remote control S
255/11 5WG12557AB11 (S3 = On / S4 = Off).
Programming mode
A short push of programming button (< 2 s) enables the programming mode. This will be indicated by a
continuous light at the programming mode LED. A second push disables this mode.
Factory settings (UP 258D12 and UP 255D21 only)
A very long push of the programming button (> 20 s) effects a reset to factory settings. This is indicated
by constant flashing for 8 seconds.
Note (UP 258D12 and UP 255D21 only)
A long push of the programming button (> 5 s to 20 s) enabled the Connection Test for commissioning
with Desigo. This mode can be disabled by a short push any time.
Siemens AG
Building Technologies Division
Control Products and Systems
P.O. Box 10 09 53, D-93009 Regensburg
UP 258E22, UP 258D12, UP 255D21
ã Siemens AG 2015
Subject to change
Update: http://www.siemens.com/gamma-td
H1
H2
H3
9 / 12
January 2015