Snapper 1685336 Installation Instructions

GENERAL
The Spring Assist Kit is used to retrofit the hitch used to
install the 42" and 46" Snow Plow/Dozer Blade on
several different models (series) of tractors. For easier
understanding of this instruction sheet, first identify the
size of blade (42" or 46") and group of tractor on which
you are working. Follow these specifications throughout
the ten steps.
Tractors:
Group 1: 600,4000,5000
Group 2: 800,600O
Group 3: 700,700O
Group 4: 900, 7100
Snow Plow/Dozer Blade:
42"
42"
46"
IT
PARTS
Mounting location for 42" blade on Group 2 tractors
Use 0, 1, 2 or 4 links
Mounting location for 42" Group 1, 3 and 4 tractors
46" blade on Group 3 z&d 4 tractors
Ref. Description
A. NUT, Hex Lock, 5/l&18
WASHER, Plain, 5/16
C.
D. CHAIN, 4-Links
E. SPRING
Mounting location for
1 1923362
2 1919381
1 1921977
1 1669241
1 1675232
1
INSTALLATION
INSTRUCTIONS
INSTALLATION
1. Park tractor on a flat, level surface. Shut off engine,
remove key and apply parking brake.
2. Release lift handle so that dozer blade rests on the
ground.
3. Remove spring clip from king pin (A, figure 2).
Remove king pin and pivot pin (B) from push bar.
Slide dozer blade forward and remcwe
bar.
4. Remove cotter pin (C) from rod guide(D). Remove
rod guide from hitch bracket (E). Push bar should
now be free to move up and down.
Figure 2. Dozer Blade Removal
A. King Pin
B. Pivot
C. Cotter Pin
D. Rod Guide
E. Hitch Bracket
5. Drill a hole in the bottom cross member (42" blade
on Group 1, 3 and
upper cross member (42" blade on Group 2 tractors)
according to the diagrams of the templates in figure
3. Actual templates are on a separate insert included
with these instructions.
For 46" blades on Group 3 and 4 tractors, drill a ,406"
hole in the (top) front plate. Hole should be located
rear edge. (Refer to figures 7E +7F.)
SPRING ASSIST KIT
MFG. NO. 1685336
from push
4 Series tractors) or
IN U.S.A.
878