Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux 5700 series
Summary of Contents for Electrolux 5700 series
- Page 1 Upright Vacuum Cleaner Owner’s Guide Household Type 5700-5739 Series IMPORTANT For any advice on your cleaner and to order dust bags, filters and accessories, please telephone Electrolux Floorcare Helpline 08706 055055 www.electrolux.co.uk...
-
Page 2: Important Safeguards
IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors or on wet surfaces. •... -
Page 3: Before You Start
It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. -
Page 4: Service Checklist
Spares New filters, brush rollers and drive belts can be obtained from authorised Electrolux dealers and electrical retailers. If difficulty is experienced in obtaining spares please call us on 08706 055055, visit our website at www.shop.electrolux.co.uk or send cheque orders made payable... - Page 5 Cord Retainer - To use, push electrical cord down into cord retainer. ON/OFF Switch - International symbol I means On, International symbol O means Off. Dust Bag Cover Latch - Pull up on latch to remove bag cover giving access to the dust bag and motor filter. Filter Door Latch - Push down on latch and pivot out for access to the filter compartment.
-
Page 6: Thermal Cut Off
6. After 60 minute cool down period, plug the cleaner in and push the rocker switch to the on (I) position. The cleaner should turn 7. If the cleaner still does not operate, call Electrolux on 08706 055055 for a Service Centre location close to you. -
Page 7: Attach Handle
CAUTION: Assemble the cleaner before using. CAUTION: Moving parts, make sure on/off switch is in off (0) position before plugging in. NOTE: Features may vary by model yet all parts assemble the same. Attach Hose Attach Handle CAUTION: Do not catch cord under handle. Upper Hose Retainer... - Page 8 Store Hose and Accessories Store Electrical Cord Nested Wands Cord Retainer Cord Hook Dusting Brush Cord Hook You will find your cord retainer on the handle above the upper cord hook. Firmly push the electrical cord down into the cord retainer. This will place the cord out of the way the next time you vacuum.
- Page 9 ON/OFF Switch. International symbol I means On, International symbol O means Off. WARNING: Avoid injury. Keep loose clothing, Cleaner Height Setting. An adjustment hair, fingers, and all other parts of that raises or lowers the cleaner base body away from any moving part to match the type of floor surface.
- Page 10 The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust bag, filters, belt, and brush roll often. NOTE: When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances, the dust bag and filters will require more frequent maintenance.
- Page 11 Filter Pad Replacement Options: Micron, Code EF84, includes pre-motor filter. HEPA, Code EF85, includes pre-motor filter. Use GENUINE Electrolux replacement filter pads. To Clean Pre-Motor Filter and Filter Pad 1. Remove the filter from the cleaner. 2. Shake filter to remove excess dust. If necessary, the filter can be cleaned by vacuuming with another cleaner or washing with mild detergent.
-
Page 12: How To Replace Brush Roll Belt
10. Place hood back on cleaner. Make sure hood front Brush is behind furniture guard. Replace three screws. Roll 11. Tighten screws. 3. Lift left end of brush roll. Use GENUINE Electrolux replacement belt, Code 4. Remove and discard belt. ZE090. - Page 13 To Clear Blockages in Hose Lower Hose Adapter Nested Wands Base Hose Locate lower hose adapter on the back of the cleaner. Remove lower hose adapter from rear of cleaner by lifting up and twisting. Check for blockages in the hose and base hose. Flexing the hose may help loosen any blockage.
- Page 14 All three screws must be removed from the top of the hood. Page 13. Missing parts Call the Electrolux Floorcare helpline on 08706 055055. Questions? Call the Electrolux Floorcare helpline on 08706 055055. Have the model and serial numbers ready when you...
- Page 15 The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. (example: blocked/dirty filters) Electrolux does not accept liability for all defects arising from neglect, misuse or accident.
- Page 16 Thank you for selecting an Electrolux cleaner. Don’t Forget to Use Genuine Electrolux Belts Caution: Damages caused by the use of non-genuine parts are not covered by the Electrolux Guarantee. ©2003 White Consolidated, Ltd. Part No. 72828 Printed in U.S.A.