Advertisement
Table of Contents
- 1 Table of Contents
- 2 Safety Warning and Precautions
- 3 Identification of Parts
- 4 Operating the Dehumidifier
- 5 Control Panel
- 6 Display Panel Icons
- 7 Installing Hepa/Activated Carbon Filter
- 8 Water Removal
- 9 Maintenance
- 10 Replacement Parts
- 11 Helpful Tips
- 12 Troubleshooting
- 13 Technical Data
- 14 Warranty
- Download this manual
Advertisement
Table of Contents
Summary of Contents for Aerus Pure & Dry
- Page 1 2 in 1 Dehumidifier and HEPA Air Purifier READ AND KEEP THIS MANUAL FOR REFERENCE PURPOSES 00947-1913_EA-03788...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Warning and Precautions ............2-3 Identification of Parts. -
Page 3: Safety Warning And Precautions
SAFETY WARNINGS AND PRECAUTIONS CAUTION: Your safety and the safe operation of this dehumidifier are very important to us. All safety and operating instructions should be read, adhered to and followed before the unit is operated. Incorrect operation may cause harm or damage. This dehumidifier is for indoor use only! When using your Pure &... -
Page 4: Identification Of Parts
IDENTIFICATION OF PARTS Control Panel Washable Pre-Filter Air Purification (HEPA/ Activated Carbon Filter) Front Panel Filter “Time Reset” Air Inlet Handle Louver Bucket Lid Float Continuous Drain Hose Outlet Water Level Window Water Bucket... -
Page 5: Operating The Dehumidifier
8 control buttons and Display Screen With these, you control the function of your Aerus Pure & Dry Dehumidifier. As long as the dehumidifier is plugged in to a 120V outlet, four items will always be displayed in the Display Screen: Relative Humidity, Temperature, HEPA filter (installed or not), and HEPA Filter Timer. - Page 6 CONTROL BUTTONS: ON/OFF Press the ON/OFF button to turn the dehumidifier ON and OFF. The dehumidifier remembers the last setting and starts in that mode. MODE Press the MODE button to change between one of 5 operating modes. The mode changes each time the button is pressed.
- Page 7 SAFETY LOCK mode. To unlock, press and hold the button for 3 seconds. AUTOMATIC TIMER “on” at some time in the future. Press the AUTOMATIC TIMER button. The temperature icon will be replaced by the number push and hold, or push and release the AUTOMATIC TIMER button to increase the time from 1 to 24 hours in 1 hour increments.
-
Page 8: Display Panel Icons
DISPLAY SCREEN ICONS: Automatic Mode Icon: Displayed when the dehumidifier and air purifier run simultaneously. Continuous Dehumidification Mode Icon: Displayed when the dehumidifier is running continuously. Drying Mode Icon: Displayed when the fan and dehumidifier are running and using a drainage hose. - Page 9 10. Night Mode Icon: Displayed when Night Mode is activated and the fan drops to its lowest level. Temperature + Timer Display Icon: Displays the ambient temperature of the room. During the Timer Mode, it will display operational time; if you use the Timer Mode to start the machine, both Timer and ON will display on the panel;...
-
Page 10: Installing Hepa/Activated Carbon Filter
INSTALLING HEPA/ACTIVATED CARBON FILTER CAUTION: Disconnect power before changing filter. You have the ability to filter and purify air with your Pure & Dry dehumidifier by using the HEPA/Activated Carbon Filter. Activated Carbon Filters can effectively remove VOCs, dust, smoke and odors from the air. HEPA filters effectively remove dust and allergens. Once the unit reads that the filter has been installed, the Air Purification Mode will light up and the interior fan will begin to run at high speed. -
Page 11: Water Removal
WATER REMOVAL WARNING: To avoid electric shock, disconnect power before removing collected water. There are two ways to remove collected water: Manual Drainage or Automatic Drainage MANUAL DRAINAGE • When the water bucket is full, the FULL BUCKET indicator light will flash and the unit will beep for 10 seconds •... - Page 12 Pry Up WATER REMOVAL (CONTINUED) Step Three: Take out the water tank and push aside the water outlet pressure plate. Step Four: Connect the Drainage Hose with suitable length to the Before drain port (insert about 10 mm). See following page for more information.
-
Page 13: Maintenance
MAINTENANCE REPLACING THE HEPA/ACTIVATED CARBON FILTER WARNING: Cleaning the HEPA/Activated Carbon Filter with water will damage the lter and require the purchase of a replacement. Depending upon usage and environment, we recommend you change the HEPA/Activated Carbon Filter each season but no less than once every 8 months. The unit will keep track of how •... -
Page 14: Replacement Parts
MAINTENANCE WARNING: ALWAYS turn off and unplug the dehumidifier before cleaning. CLEANING THE WASHABLE PRE-FILTER Air circulation can be impeded and the efficiency of the dehumidifying and air purifying functions decrease when the filter is dirty. It is good practice to clean the washable Pre-Filter at regular intervals. -
Page 15: Helpful Tips
HELPFUL TIPS • Any residual water in the tank should be drained before operating the unit • Do not directly expose the dehumidifier to direct sunlight while in operation, as it may impact dehumidification capacity • When the dehumidifier is in operation, open outside windows and doors only when necessary •... -
Page 16: Troubleshooting
TROUBLESHOOTING PROBLEM POTENTIAL CAUSES SOLUTIONS • Power failure/outage • Ensure unit is plugged into a proper power supply • Water bucket is full or not properly positioned • Empty water bucket and not operate insert bucket into the unit properly •... -
Page 18: Warranty
This entire warranty shall continue to be valid, legal, and enforceable in any jurisdiction where a similar determination has not been made. This warranty is provided by: Aerus Health Direct, LLC 300 East Valley Drive Bristol, VA 24201(in US); SERVICE Every effort is made to ensure customers receive an up-to-date instruction manual on the use of our products;... - Page 20 For information regarding the use of this product please contact Customer Service. Email: support@aerusonline.com Toll Free: 1-888-764-0693 Aerus LLC 300 East Valley Drive, Bristol, VA 24201 Aerus Canada, Inc. 3480 Laird Road, Suite 2-5, Mississauga, Ontario L5L 5Y4 Made in P.R.C. © Aerus LLC 2017...
Need help?
Do you have a question about the Pure & Dry and is the answer not in the manual?
Questions and answers
How do I change the percent humidity setting?
To change the percent humidity setting on the Aerus Pure & Dry dehumidifier, use the Humidity Set Key (%) on the control panel. This allows you to adjust the humidity level within the available range of 40% RH to 70% RH.
This answer is automatically generated
I have a house connected to the back used to drain out the water now it doesn’t. I look to make sure it’s not plugged I don’t see anything. What else should I look for?