Advertisement
CAUTI O N-ELECTRI C ALLY OPERATED PRODUCT:
NOT RECOMMENDED FOR CHI L DREN UNDER 8 YEARS OF AGE, AS WI T H ALL ELECTRI C PRODUCTS, PRECAUTI O NS SHOULD BE
OBSERVED DURI N G HANDLI N G AND USE TO PREVENT ELECTRI C SHOCK, I N PUT: 1 20V AC 60Hz 300mA, O UTPUT: 7. 5 V DC 1000mA.
VEHICLE
CONTROLLER
RECHARGABLE
8+
x3
6.0V Ni-MH
x1
#94155
BATTERIES INCLUDED
BATTERY INCLUDED
Important! Carefully read the Owners Manual before play!
Advertisement
Table of Contents
Related Manuals for Nikko VaporizR 2
Summary of Contents for Nikko VaporizR 2
- Page 1 CAUTI O N-ELECTRI C ALLY OPERATED PRODUCT: NOT RECOMMENDED FOR CHI L DREN UNDER 8 YEARS OF AGE, AS WI T H ALL ELECTRI C PRODUCTS, PRECAUTI O NS SHOULD BE OBSERVED DURI N G HANDLI N G AND USE TO PREVENT ELECTRI C SHOCK, I N PUT: 1 20V AC 60Hz 300mA, O UTPUT: 7. 5 V DC 1000mA. VEHICLE CONTROLLER RECHARGABLE...
-
Page 3: Batteries And Charger
CAUTION WARNING! CHOKING HAZARD Small parts. Not for Children under 3 years. Only operate the product and its accessories when fully assembled and in accordance with this manual! This product and its accessorries are not suitable for children under the age of 36 months, because of small parts that can be swallowed. -
Page 4: Battery Charging And Care
BATTERY CHARGING AND CARE NOTE: NICKEL-METAL HYDRIDE BATTERIES MUST BE RECYCLED OR DISPOSED Contact your local area office of solid waste management or other PROPERLY. appropriate local agency for information. WARNING: The transformer/ charger is not a toy. Regularly examine charger and battery pack for leaking, corrosion, damage, including plugs, casings and all other parts. -
Page 5: Recharging Instructions
RECHARGING INSTRUCTIONS Plug the battery pack charger into a standard household outlet. Connect the battery pack to the charger as show in page 5. Red light on the charger to show that the charger is operating. Normal charging time is 60-80 minutes. Red light will blink continuously when the battery pack is fully charged. - Page 6 CONTENTS & FEATURES 1.5V (AAA/LR03) Transmitter battery x3 NiMH Battery charger 6.0V NiMH battery pack ANTENNA ASSEMBLY Insert antenna wire Slide tube down from product into tube. antenna wire and into hole in product. Tie knot with any remaining antenna wire (Do not pull wire tight).
- Page 7 TRANSMITTER BATTERY INSTALLATION To remove battery lid, loosen screw to open. Slide open the battery lid in the direction as 1.5V shown in the figure, while lightly pressing its 1.5V center. Insert 1.5V (AAA/LR03) batteres x3 with the 1.5V polarity (+/-) as shown on the bottom of battery compartment.
- Page 8 OPERATING R/C VEHICLE TURN VEHICLE POWER ON. (Push both sticks forward) (Pull both sticks backwards) FORWARD BACKWARDS (FORWARD) (Push right stick forward) (FORWARD) (Push left stick forward) LEFT TURN RIGHT TURN (BACKWARDS) (Pull right stick backwards) (BACKWARDS) (Pull left stick backwards) RIGHT TURN LEFT TURN (At the same time, pull left stick back...
- Page 9 TROUBLESHOOTING AND CARE FOR R/C VEHICLE LIMITED RADIO CONTROL RANGE INTERFERENCE While R/C vehicle may be visible at a distance, full Other radio signals may cause loss of control. operational control may be lost. Hold controller Remove vehicle from an area of interference. high in the air and direct vehicle back.
-
Page 10: Cleaning And Maintaining
CLEANING AND MAINTAINING Brush areas where dirt and Wipe body off with a soft rag Do not clean vehicle with dust get trapped. or tact cloth. chemicals. FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 12 www.toystate.com...
Need help?
Do you have a question about the VaporizR 2 and is the answer not in the manual?
Questions and answers