Table of Contents
Advertisement
Information and Error Codes
Information Codes
•
These codes may appear on the display
•
Codes indicating a value, function or state
Information
Code
Cln
Clnt
cont
cool
ECLO
End
Fill
LOAd
oPEn
PrEH
Soap
Strt
Stby
Error Codes
•
These codes may appear on the display.
•
Codes indicating the need to contact the Stoddart Service Department
Error Code
EH20
EFUN
E---
EPt1
EPt2
EPt3
EPt4
EPt8
ESCH
Etub
Etuc
EFLP
ETC
ETB
•
If an error code is displayed during a cooking cycle, the oven emits a continuous audible warning signal and the cooking cycle is interrupted.
•
In this case the oven can be used only in cooking modes that do not involve the conditions that generated the error.
•
Notify the Stoddart Service Department of the alarm code displayed.
www.stoddart.com.au
Cleaning system program switched on
Semiautomatic cleaning program switched on
Unlimited time setting
Oven cooling on
Clock error appears if the time has never been adjusted. To eliminate the error set the time
End of a cycle function
Boiler filling. (Ensure water supply isolation valve is open)
Place the food in the oven
Boiler discharge valve opening
(Time TM / PRB DISPLAY) Boiler Preheating.
(COMPARTMENT TEMP. DISPLAY TS) Automatic compartment preheating
Spray undiluted oven cleaner onto soiled areas as per Page 3 Daily Cleaning Step 2
Press the START button to start the program
CLEANING SYSTEM - Cleaning standby time
Water supply pressure too low for CLEANING SYSTEM (pressure requirements from 1.5 to 2.5 bar)
Fan automatic reset thermal switch device. UP appears on the small DISPLAY with reference to the single fan (6-10GN)
or upper fan (20 GN) of the chamber and DO in reference to the lower fan (only 20 GN)
Non-compliance with a parameter requirement (number of parameter appears in place of dashes "---")
Chamber sensor interrupted or short-circuited
Boiler sensor interrupted or short-circuited
Probe sensor interrupted or short-circuited
Bypass sensor interrupted or short-circuited
Electronic controller temperature sensor damaged
Malfunction of commands control circuit cooling devices
Boiler over temperature (125°C) warning
Chamber over temperature (320°C) warning
Fault in chamber steam discharge motor-operated valve
Tripping of chamber temperature limiter.
Tripping of boiler temperature limiter
Information Code Description
Error Code Description
Page 10
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Air-O-Steam - Dial Control 6-1/1 and is the answer not in the manual?
Questions and answers
Oven shows EFLP sign when i put that in cleaning but it is not heating up now
The Electrolux Air-O-Steam - Dial Control 6-1/1 oven is displaying an EFLP error code because there is a fault in the chamber steam discharge motor-operated valve. This issue can prevent proper steam management, which may affect the heating process during cleaning. It is recommended to contact the Stoddart Service Department for further assistance.
This answer is automatically generated