Re-Calibration - MEGAWHEELS HOVERBOARD User Manual

3.3 RE-CALIBRATION

If your MEGAWHEELS
the system indicator flashing red light together with beep voice and other
situations that the board seems to be unbalanced, you may need to
recalibrate its sensors. To calibrate your unit, follow the instructions below.
Step 1- Power your hoverboard off
Step 2- Place your MEGAWHEELS
bases are level to the ground.
Step 3- Long press the power button and keep your finger on it, the system
indicator light on the hoverboard will be on and flash for 5 times and come
out a beep voice.
Step 4- Release your finger, the system indicator light will keep on, and
then press the power button to power it off.
Step 5- Power on the hoverboard again, the balance is adjusted.
Keep level
Lights flashing
If the MEGAWHEELS
contact customer support for additional assistance.
®
seems to pull to the left or right during your ride, or
®
®
can't be calibrated correctly, repeat step 1 to 5 or
11
horizontally, make the both wheel
Press for 5S
Turn off