A Problem With Your Appliance ? - TEFAL Fasteo Manual

A problem with your appliance ?

PROBLEMS
Your iron is producing little or no
steam.
Water runs out of the holes of the so-
leplate.
Water streaks appear on the linen.
Brown streaks come through the
holes in the soleplate and stain the
linen.
The soleplate is dirty or brown and
may stain the linen.
Steam or water escapes under the
base of the appliance.
The "anti calc" indicator is flashing.
The anti calc indicator is still flashing
after replacing the cartridge.
If you have any problems or queries please call our Customer Relations team first for expert help and advice: 0345 602 1454
Environment protection first !
i Your appliance contains valuable materials which can be recovered or recycled.
‹ Leave it at a civic waste disposal centre.
You have just filled the tank or chan-
ged the anti-calc cartridge, or you
have just started using it.
There is no anti calc cartridge in the
appliance or it is not properly instal-
led.
Steam cannot be produced at the
temperature you have selected.
The water tank is empty.
You are using steam for the first time
or you have not used it for some
time.
The setting is not correct (1 dot / 2
dots) and the soleplate is not hot en-
ough to produce steam.
Your ironing board is saturated with
water because it is not suitable for
use with a steam generator.
You are using chemical descaling
agents or additives in the water
ironing.
Your linen is not rinsed sufficiently or
you have ironed a new garment be-
fore washing it.
You are ironing at too high a tempe-
rature.
You are using starch.
The appliance is faulty.
The anti calc cartridge is no longer
efficient.
You have not pressed the reset
button.
UK / (01) 677 4003 - ROI or consult our website - www.tefal.co.uk
CAUSES
19
SOLUTIONS
Press the steam control button conti-
nuously for few minutes pointing it
away from your linen, in order to
prime the pump.
Make sure the anticalc cartridge is
installed and locked down in its com-
partment.
Set the thermostat control in the co-
loured zone (••• or MAX).
Fill the tank.
Press on the steam control button
away from your ironing board until
the iron produces steam.
Set the iron at 3 dots (••• or MAX)
and wait for the iron thermostat light
to go out before activating the steam
button again.
Check that your ironing board is
suitable. We recommend that you
use a vented/mesh type ironing
board.
Never add this type of product in the
water tank (see "for what water may
be used"). Contact an Approved Ser-
vice Centre.
Ensure linen is rinsed thoroughly to
remove any soap deposits or chemi-
cals on new garments which may be
sucked up by the iron.
See our recommendations regarding
temperature control setting.
Always spray starch on the reverse
side of the fabric to be ironed.
Stop using your appliance and
contact an Approved Service Centre.
Replace the anti calc cartridge with a
new one then press the reset button
for a minimum of 3 seconds.
Press the reset button until the light
stops flashing.