Advertisement
PRESSCONTROL
WALL PRO
VARIABLE FREQUENCY DRIVE FOR CONTROL AND PROTECTION
OF THE PUMP
PRESSCONTROL WALL PRO CAN OPERATE 400V THREE-PHASE PUMPS UP TO 15 HP.
Wall-mounted near the pump.
Varies the number of motor revolutions of the pump depending to the water withdrawal from the
system in order to maintain constant pressure and flow rate.
Allows to regulate the system pressure and the restart pump pressure.
Stops the pump in case of water shortage and protects it from dry running.
Is equipped with automatic restart in case of failure and anti-jamming function.
Can be installed on surface and submersible pumps.
Ensures energy saving.
Can be installed on surface pumps and submersible pumps.
Supplied with a 16 bar pressure sensor.
Standardly equipped with a communication interface to make pressure sets.
Standardly equipped with BMS protocol connection interface (Building Management System).
Standardly equipped with NFC technology for data transfer to the mobile phone.
Advertisement
Table of Contents
Summary of Contents for WaterTech PRESSCONTROL WALL PRO T9
- Page 1 PRESSCONTROL WALL PRO VARIABLE FREQUENCY DRIVE FOR CONTROL AND PROTECTION OF THE PUMP PRESSCONTROL WALL PRO CAN OPERATE 400V THREE-PHASE PUMPS UP TO 15 HP. Wall-mounted near the pump. Varies the number of motor revolutions of the pump depending to the water withdrawal from the system in order to maintain constant pressure and flow rate.
-
Page 2: On/Off Button
CONTROL AND SETTING PANEL Setting up and starting Presscontrol Wall Pro is an extremely easy and intuitive operation thanks to the large and bright display that shows the information and the keyboard that allows you to enter and modify the pump operating parameters rapidly. DISPLAY The figure shows an example of displaying information divided into 4 quadrants: 2 - Real system pressure... -
Page 3: Installation And Start-Up
INSTALLATION AND STARTUP Install the device on a wall near the pump (fig. 1). Connect the supplied pressure sensor, make the electrical connections and energize. Arrange the use of an expansion tank sized according to the hydraulic characteristics of the system. To startup the pump, follow the instructions that will appear in sequence on the display of the device: - Language selection. -
Page 4: Operation
PRESSURE SETS Presscontrol Wall PRO is equipped with a communication interface that allows up to 4 devices to communicate simultaneously. INSTALLATION AND SETUP Connect the devices together using the serial port. Program the Presscontrol Wall PRO selected as Master following the instructions on the display. Enable communication on the Master Presscontrol Wall PRO that automatically will transfer the data to the other connected Presscontrol Wall PRO units that will act as Slave devices. -
Page 5: Installation And Setup
PRESSURE SETS It is possible to control up to 4 pumps with a single Presscontrol Wall PRO, guaranteeing the alternation of the pumps under inverter by an electronic box supplied as an option. INSTALLATION AND SETUP Connect the Presscontrol Wall PRO to the electronic box using the serial port. Program the Presscontrol Wall PRO according to the instructions on the display and enable communication. - Page 6 PRESSCONTROL WALL PRO MODELS AND TECHNICAL FEATURES MODELS T 12 T 16 T 19 T 23 Mains voltage 3 ~ 400 Vac 3 ~ 400 Vac 3 ~ 400 Vac 3 ~ 400 Vac 3 ~ 400 Vac Acceptable voltage fluctuations +/- 15% +/- 15% +/- 15%...
Need help?
Do you have a question about the PRESSCONTROL WALL PRO T9 and is the answer not in the manual?
Questions and answers