Replace The Blades; Software Update - Gardena SILENO city Operator's Manual

5.2.4 Charging station
Clean the charging station regularly from grass,
leaves, twigs and other objects that may impede
docking.
WARNING: Use the plug to disconnect
the charging station before any
maintenance, or cleaning of charging
station or power supply.

5.3 Replace the blades

WARNING: Use blades and screws of
the right type. GARDENA can only
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use
GARDENA original blades embossed with the
crowned H-mark logotype, refer to
terms on page 52 .
5.3.1 To replace the blades
1. Press the STOP button.
2. Open the hatch.
3. Press the ON/OFF button for 3 seconds to
turn off the product.
34 - Maintenance
4. Check that the indicator lamp on the
ON/OFF button is not lit.
5. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the hatch.
6. Remove the 3 screws. Use a straight slot or
cross-tip screwdriver.
Guarantee
7. Remove each blade and screw.
8. Fasten new blades and screws.
9. Check that the blades can pivot freely.

5.4 Software update

If service is done by GARDENA customer service
then available software updates are downloaded
to the product by the service technician.
However, owners of GARDENA products can
update the software if this is initiated by
GARDENA. Registered users are in that case
notified.
953 - 002 - 12.12.2018