Warning Scenario Table; Doffing; Maintenance; Filters - JSP Powercap Infinity User Manual

WARNING SCENARIO TABLE:

SCENARIO DISPLAY
Start up Red, green, blue
Standard running Green static
Draining battery Green (Red flash every 2s)
Flat battery Red flash
Blocked filters Blue flash
Other fault Red, blue (repeat)
DOFFING: (DO NOT remove the product whilst in the hazard zone)
1. Pull the tabs on the seal-skirt outwards and upwards to raise the visor.
2. Turn the red wheel anti-clockwise to loosen the helmet. Lift the assembly off the head.
3. Press and hold the power button on the battery pack to switch off. The adjacent battery charge level indicator will light momentarily to display the
remaining charge level.
1 2
TAB

MAINTENANCE:

It is important to follow the following instructions to ensure that the PowerCap
the maintenance and usage instructions in this leaflet are not followed, the effectiveness and the protection offered by the PowerCap
severely reduced. A radio frequency identification (RFID) device has been built in to PowerCap
using JSP's Asset Management system. This allows you to have full control over your PowerCap
dates, compliance documentation, product instructions and much more. Visit www.jspcheck.com to enable your RFID device.

FILTERS:

• The filters provided are high efficiency particulate types supplied in pairs.
• They will filter most particulate matter such as dust, spores, mist and fumes.
• They will not filter gases, vapours or toxic substances.
• PowerCap Infinity filters are marked as per right image.
® ®
Only use genuine PowerCap Infinity filters supplied in pairs from
® ®
JSP Ltd or its distributors. Always replace both filters simultaneously.
NEVER use compressed air on the filters. This will seriously limit protection.
BUZZER COMMENTS
On (2s) System OK
Off System OK
Off 20 minutes remaining
High-low tone Recharge battery
High pulsed Change BOTH filters
High pulsed Contact JSP Ltd
3
CHARGE LEVEL
POWER
Infinity gives optimal performance. Regular maintenance is important. If
® ®
Infinity
®
Infinity so that your maintenance records can be kept
® ®
Infinity giving full access in the field to inspection
® ®
8
REMOVING & REPLACING FILTERS:
To Remove the Filters: Rotate the rear of each filter upwards by 30° until resistance is encountered, then pull away from the motor housing.
To Replace the Filters: Ensure that the filter and motor housing mating faces are clean; do not allow any dust or foreign objects to fall into the motor
housing. Press and twist the replacement filters into place until a click is heard/felt. Recheck airflow before use. (See Battery and Airflow Check).
If the filters are not fitted correctly, filtering efficiency will be severely reduced. Each filter is fitted with a pre-filter housed within a protective cover.
Pre-filters prolong the life of the main filters by trapping larger particles. The pre-filters can be replaced from within the protective covers as needed.
Dispose of used filters in accordance with local legislation.
REMOVING & REPLACING PRE-FILTERS: (Always replace both pre-filters simultaneously)
1. Locate the tab at the rear of the pre-filter cover and lift it to begin freeing the cover.
2. Release the two remaining hooks from under the front of the main filter case lid to release the cover from the main filter body.
3. Pull the pre-filter out from under the three locating hooks. Dispose of used pre-filters in accordance with local legislation.
4. Clean the pre-filter cover using a damp cloth and/or soft brush, then feed a fresh pre-filter underneath the three locating hooks.
5. Clip the pre-filter cover back onto the filter, locating the curved front edge first.
6. Snap the rear clip into place over the rear of the filter case lid.
1
may be
®
1
4
1
30°
2 3
HOOKS
5 6
9
30°
PRE-FILTER