Adjustable Arm Rest Installation And Adjustment - OAKWORKS ProLuxe Series User Manual

DIRECTIONS FOR USE

ADJUSTABLE ARM REST INSTALLATION AND ADJUSTMENT

CAUTION
TO INSTALL THE ARM RESTS:
The Arm Rests adjust automatically as the back rest moves to remain parallel to the floor.
1. Insert end of arm rest into backrest
hole while holding the arm rest at a
60° angle to the backrest.
TO LEVEL THE ARM RESTS:
The Arm Rest height is adjusted at the factory for each table. If the armrest starts to sag with repeated use, follow the
steps below to readjust.
1. Loosen the bottom 2 set screws.
Do not use the arm rest for patient support during the mounting or dismounting of the chair.
The arm rest is not designed to support the patient's weight.
2. Push end all the way into the hole and drop the arm rest into the horizontal position.
Pull outward to make sure the arm rest is secure.
2. Turn the side set screw (clock-
wise to raise or counter-clockwise
to lower) while adjusting the arm
rest. Lift the arm rest slightly
when doing this adjustment to
reduce the weight.
3. Tighten the two bottom set
screws to lock the position.
15