Table 2-6. Mid Power Trunnion Kit - Motorola APX 8500 Installation Manual

Standard Configurations Radio Mounting
2.2.1 Dash Mount with Trunnion - Mid Power
1. Select the location to mount your radio on the transmission hump (see
the dash (see
NOTE: When mounting the trunnion on the transmission hump take care that the transmission
housing is not affected. Plan your installation ensuring enough room for the Accessory
connector and cable in the back of the radio.
2. Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3. Center punch the spots you have marked and realign the trunnion in position.
4. Secure the trunnion mounting bracket with the four self-drilling screws provided
(see Figure 2-25
5. Ensure that the plastic guides are aligned (horizontal) to the grooves of the trunnion. Slide the
radio into the grooves until it snaps into place (see
Item Part Number
1 0371859H01
2 0312002B14
3 HLN7002_
HLN7003_
4
MN003109A01_aa
Draft
Figure 2-26)
and Figure 2-26).
Table 2-6.
Description
Trunnion Mounting Screw
Self-Drilling Tapping Screw
Mackinaw Trunnion Hardware Kit
Mackinaw Trunnion Hardware Kit
1
3
Threaded Hole
for Screw
Figure 2-25. Below Dash Trunnion Mounting
Figure 2-26).
Mid Power Trunnion Kit
High/Mid Power Transceiver
APX 8500
APX 8500
APX 8500
APX 8500
2
Tabs
Plastic
Guides
Groove
2-23
Figure 2-25) or under
1