Initial Network Configuration (Ip Address) - Stratasys FDM Titan User Manual

Setup & Installation

Initial Network Configuration (IP Address)

Before operating the machine, you must enter the IP, Netmask, and Gateway
addresses.
1. Power up the machine, as shown on page 5-3.
2. From the Ready screen, select Maintenance and press ENTER.
Build Job..
Operator Control..
Modeler Status..
>Maintenance..
3. Select Administration and press ENTER.
Modeler Default..
>Administration..
Reboot Machine..
4. Select Network Configuration and press ENTER.
>Network Configuration..
Receive Software Upgrade or Code..<E>
Field Service..
5. Select IP and enter the address using the keypad. Press ENTER. You can use the
DEL key to erase incorrect entries.
6. Select MASK (Netmask) and enter the address. Press ENTER.
7. Select GW (Gateway) and enter the address. Press ENTER.
>IP
MASK:
GW
Note: See your system administrator if you do not know the IP, Netmask, or
Gateway address.
2 - 4
password:
: [172.16.70.10]
(.none found)
: [172.16.100.1]
| *Tips: Model T16
| * Support T16
FDM Titan User Guide