Fluotec VegaLux 200 HP Manual page 2

High-Performance StudioLED FRESNEL
Table 1. Menu VegaLux 200
Menu VegaLux 200
ADDR (001,512)
DMX
RUN
SLAVE
MODE
REST
SET PASS
KEY
1 (0,100)
ZOOM
DIMM
2 (0,100)
Fixture operates with two DMX Channels:
• DMX Channel 1 - DIMMER
• DMX Channel 2 - ZOOM
VegaLux 200 StudioLED FRESNEL
HP
®
MENU: Return to previous menu.
ENTER: Next submenu or function.
UP and DOWN: Navigation buttons in the same level of the menu or
submenu and serve us to select some value.
Main keyboard menu functions:
Here we can assign the initial DMX Address to our unit (D.000 D.512)
ADDR
Here we can configure the unit it has 9 functions
SET
Enables function "Keyboard blocking"
KEY
Enables "Keyboard blocking". If this option is selected the
keyboard will be blocked and it will not function unless
ON
the password is introduced
Disable "Keyboard blocking"
OFF
Enables function "Performance mode"
MODE
STUDIO MODE. When you need the less noise possible
STDO
LIVE MODE. Increases the power of the unit and the
LIVE
ventilation power (some noise may be heard)
POWER MODE. Maximum lighting and ventilation power
POWR
(some noise may be heard)
Reset all default values to factory settings. Password required
RSET
Illumination power adjust (Dimming) (D.000-D.100)
DIMM
Zoom adjust (Z.000-Z.100)
ZOOM
Here you can configure the DMX or SLAVE MODE of use
RUN
All units set to DMX will receive and answer DMX signals
DMX
according to the channel selected
All units set to SLAV will receive and answer the signals of other
SLAV
connected Fresnels
Password
All menus where PASSWORD is required have to enter the following sequence.
Motorized Zoom
®
StudioLED FRESNEL
HP
® ®
StudioLED FRESNEL
HP
® ®
DMX Adress
DMX MODE Execution
SLAVE MODE Execution
STDO STUDIO MODE Performance
LIVE LIVE MODE Performance
POWR Maximum Performance
Reset all default values.
Password required
Enables keyboard blocking after
ON a determined time. You will only
be able to unlock with password.
OFF Disable keyboard blocking.
Motorized zoom control Spot-Flood
Dimming
has four buttons to control its functions:
®
Warnings
VegaLux 200 StudioLED FRESNEL
HP
®
system. Read these instructions, as well as accessory instructions and applicable
warnings before operating.
• Do not leave fixture unattended.
For fixed (stationary) use in studios, theaters, and similar locations.
• Not for household use. Use only for photographic lighting (television, video
& film).
• Always unplug unit before changing fuse.
• Do not use near standing water.
• Never bypass plug's ground pin.
• Do not interfere with unit's ventilation.
• Do not operate unit with Accessory Barndoors closed.
• Make sure clamp is tightened at yoke.
• Always use Safety Cable, when attaching to overhead pipes or grids.
• Always use with supplied AC Cable.
LED Warnings
• Avoid looking directly at the LED's for extended periods of time.
General Recommendations
1. Do not operate this product if it's damaged.
2. To protect yourself from an electrical discharge, avoid contact with water
or other liquids.
3. The UNIT HAS TO BE POWERED OFF before you connect it to the
electrical grid, also when striking the UNIT turn it off before disconnecting it
from the power grid.
4. In case of failure or malfunction to avoid electrical discharge, DO NOT
disassemble this UNIT call your FLUOTEC
Wrong reassembly or disassembly of this unit may cause a malfunction.
5. The use of accesories not designed or recommended by FLUOTEC can
cause hazardous conditions or damage the fixture.
Cleaning
CHASIS.
Use a moist, almost dry cloth to remove dust and any stain.
NEVER USE ANY ABRASIVE FIBER PAD AND NEVER USE SOLVENTS.
They can damage the fixture or it's finish.
Problems, repairs & info
Repairs, problems, suggestions and requests for brochures/catalogs,
instructions and parts lists can be handled through your Authorized FLUOTEC
Dealer/Distributor or directly through FLUOTEC
made only by FLUOTEC or by a qualified electrician.
®
FLUOTEC
®
International Sales
Tel. 1 (877) 556 5554
Email info@fluotec.net
equipment is a professional lighting
®
AUTHORIZED SERVICE CENTER.
®
. Electrical repairs should be
®
www.fluotec.net
®