Siemens SIMATIC HMI Operating Instructions Manual page 6

Preface
Photos
The HMI device is sometimes shown in the form of photographs in these operating
instructions. The photographs of the HMI device may differ slightly from the factory state of
the HMI device.
Conventions
Configuration and runtime software differ with regard to their names as follows:
● "WinCC flexible 2007" for example, refers to the configuration software
● "WinCC flexible Runtime" refers to the runtime software that can run on HMI devices
The name "Mobile Panel 277 Wireless" is the collective term for the following HMI devices:
● Mobile Panel 277 IWLAN
● Mobile Panel 277F IWLAN
The following text notation will facilitate reading these operating instructions:
Notation
"Add screen"
"File > Edit"
<F1>, <Alt+P>
Please observe notes labeled as follows:
Note
Notes contain important information concerning the product, its use or a specific section of
the documentation to which you should pay particular attention.
Registered trademarks
Names labeled with a ® symbol are registered trademarks of the Siemens AG. Other names
used in this documentation may be trademarks, the use of which by third parties for their
own purposes could violate the rights of the owner.
● HMI
● SIMATIC
● SIMATIC HMI
● SIMATIC ProTool
● WinCC
6
The term "WinCC flexible" is used in a general context. The full name, for example
"WinCC flexible 2007", is always used when it is necessary to differentiate between
different versions of the configuration software.
®
®
®
®
®
Scope
Terminology that appears in the user interface, for example
•
dialog names, tabs, buttons, menu entries
Inputs required, for example limit values, tag values
•
Path information
•
Operational sequences, for example, menu commands, context
menu commands
Keyboard operation
Operating Instructions, 12/2007, A5E01003940-01
Mobile Panel 277F IWLAN