Table of Contents
Advertisement
Specifications
Height
Length
Width
RPM (Full Speed)
Aeration width
Coring range
Holes per square foot
Tines
Weight
A selection of Exmark approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor.
To best protect your investment and maintain optimal
performance of your Exmark equipment, count on
Toro genuine parts. When it comes to reliability,
Exmark delivers replacement parts designed to the
exact engineering specification of our equipment. For
peace of mind, insist on Exmark genuine parts.
129.5 cm (51 inches)
173.2 cm (68.6 inches)
90.2 cm (35.5 inches)
3800 ± 100 RPM (no load)
61 cm (24 inches)
1.3 to 12.7 cm (0.5 to 5 inches)
4.6
36
388 kg (856 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Open the Fuel-Shutoff
Valve
Rotate the lever counterclockwise to open.
Starting the Engine
1.
Leave the motion-control levers in neutral and
engage the parking brake.
2.
Place the throttle midway between the S
and F
positions.
AST
3.
On a cold engine, push the choke lever forward
into the O
position. On a warm engine, leave
N
the choke in the O
4.
Turn ignition switch to the S
Release the switch as soon as the engine starts.
Important:
Do not crank the engine
continuously for more than 10 seconds at
a time. If the engine does not start, allow
a 60-second cool-down period between
starting attempts. Failure to follow these
guidelines can burn out the starter motor
5.
If the choke is in the O
return choke to the O
warms up.
Lowering the Tines
DANGER
The rotating tines under the engine deck are
dangerous. Tine contact can cause serious
injury or kill you.
Do not put hands or feet under the machine
when the engine is running.
1.
Set throttle to the F
2.
Tap the switch once to display the tine
engagement depth setting; adjust if necessary.
3.
Lower the tines by pressing on the tine ground
engagement foot switch.
4.
Stand on the switch and move the motion-control
levers forward to aerate.
Note:
You can adjust the foot rocker bar,
located behind the tine ground engagement foot
switch for your comfort. To adjust it, loosen the
21
LOW
position.
FF
position.
TART
position, gradually
N
position as the engine
FF
position.
AST
Advertisement
Table of Contents
