Page 1
TIPO: PFZ 02 MOD.: SGR30 The manufacturer cannot be held responsible for any inaccuracies due to printing or reproduction errors contained in the present booklet. The features of the picture diagrams included are purely indicative. We reserve the right to make any changes to our products that are deemed necessary or useful and in the interest of the user that are not detrimental to essential operating and safety features.
Page 2
BARBECUE DESCRIPTION TYPE: BD30 1 Grill 2400 W 2 Grill rack 3 Grill control knob 4 Grill on/off indicator lamp Caution: this appliance is designed for personal household use only.
Page 3
1) SWITCHING ON THE BARBECUE The barbecue is controlled by a power regulator with 12 positions (see fig. 1). Turn the knob clockwise to the desired position (from 1 to 12) to switch it on. To use the grill function turn the knob to position 12. A light click warns that the thermostat has been shut down and the resistance will quickly become red-hot.
Page 4
WARNING: When turning the grill on for the first time or if the grill has remained inactive for a long time, care must be taken to dry it out by switching on the grill for 30 minutes to position 1 on the regulator in order to eliminate any moisture absorbed by the insulating material.
Page 5
CAUTION: Before cleaning of any kind, disconnect the appliance from the mains. 2) COOKING SURFACE To maintain the surface of the barbecue always clean and to extend the lifespan of the appliance, it is very important to wash it after every use with warm, soapy water, rinse, and dry thoroughly.
TECHNICAL DATA FOR INSTALLERS Installation and maintenance listed in this section must only be carried out by qualified personnel (law n° 46 and D.P.R. 447). A faulty installation can cause damage to persons, animals or objects, towards whom the manufacturer cannot be held responsible. The cut-off or automatic control devices of the appliance can only be modified by the...
Page 7
4) SECURING THE BARBECUE To secure the barbecue to the worktop the fastening clamps accompanying this booklet must be assembled. The following procedures must be carried out to do this: remove all movable parts from the barbecue; turn the appliance over taking care to place it on a soft surface to avoid damaging the external surfaces;...
Page 8
5) ELECTRICAL CONNECTIONS The electrical connection must be made in conformity with current rules and regulations. Before making a connection, check that: - The capacity and outlets of the electrical installation are suitable for the maximum power output of the appliance (see the information label attached on the underside of the housing).
Before carrying out maintenance of any kind, disconnect the appliance from the mains. All maintenance must be carried out by authorized personnel only. 6) PART REPLACEMENT To replace components located inside the barbecue the resistance should be lifted up and secured in the vertical position.
TECHNICAL ASSISTANCE AND SPARE PARTS Before leaving the factory, this equipment was tested and adjusted by skilled personnel so as to guarantee the best operating results. Original spare parts can only be found at our technical service centres and authorized stores. Every repair or adjustment necessary thereafter must be carried out with the greatest care by qualified personnel.
Need help?
Do you have a question about the SGR30 and is the answer not in the manual?
Questions and answers