Advertisement
Quick Links
Advertisement
Related Manuals for oticon REM AutoFit
Summary of Contents for oticon REM AutoFit
- Page 1 REM AutoFit Quick Guide How to complete the REM process in under six minutes...
- Page 2 How to complete the REM process in under six minutes What is REM AutoFit? REM AutoFit is an intuitive tool in Genie and Genie 2 that allows the HCP to match real ear targets automatically. This makes the real ear...
- Page 3 The following controls are set automatically during REM AutoFit measure- ments and restored to their original states afterwards, except for Overall Tools menu in the left taskpane. Launch REM AutoFit from the bottom of the Loudness (Super Power instruments only) which stays on 0.
- Page 4 Note: if REM AutoFit adjustments are subsequently applied to the fitting (in Step 4: Finish), the unaided measurement (REUG) is saved to the REUG tool and will overwrite any previous REUG. If REM AutoFit is discarded or exited prematurely, the unaided measurement is not saved.
- Page 5 Without measured real ear data, the fitting software has to prescribe gain of performing real ear aided measurement sequences: Automatic and using average real ear data. The automatic process in REM AutoFit measures Manual. This can be selected using the tabs below the right ear graph.
- Page 6 Fitting step in Genie/Genie 2 will show a lack of gain in the high frequencies due to the risk of feedback. In this case, try a The manual process in REM AutoFit lets you fine-tune the hearing aid gain to more closed dome or earmould.
- Page 7 REM AutoFit is then restored. Removing measured real ear data If you no longer want to use the REM AutoFit adjustments and want to use the predicted data instead, do as follows: Leave the REM tool if it is open.
- Page 8 www.oticon.com...
Need help?
Do you have a question about the REM AutoFit and is the answer not in the manual?
Questions and answers