Final Assembly Steps - Universal 47-20 Installation Instruction

To determine the Length L, add the square of "Y"
5.
and take the square root of the sum.
( X * X )
6. The threaded rod will screw into the poppet cam to a depth
7. Apply thread sealant to ¼" at the end of the rod to be screw
8. Apply pipe dope to NPT thread and install the valve with the float
9. Note: There is a marked line on the valve as shown in Fig 6 to
Figure 5 Length
of Rod to be Cut
Figure 6 Marked
Line showing
Direction of
Float
of ¼". Add ¼" to the length L previously calculated to
determine the total length for cut.
onto the poppet cam. Screw on the float rod into the poppet
cam ¼". Do not over thread. When installed properly the
float rod should swing back and forth freely.
hanging in the vertical position.
indication the direction of swing for the float. Be sure to install so
that there is no obstruction to the swing of the float. The float will
swing to the right or left of the marked line for shut off.
and the square of "X"
( Y * Y)