Additional information
Break-In
Your TAGA Harmony amplifier sounds great immediately after it is taken out of the
carton but as all hybrid amplifiers, this amplifier requires a "break-in" period to reach its
full sonic capabilities.
During the "break-in" period it is recommended to operate the amplifier at moderate
volume levels.
The first level of the "break-in" is reached after approximately 10 hours of play.
The optimal level of the "break-in" is reached after approximately 40 to 60 hours of play.
It is recommended to avoid one-time short periods of operation unless the amplifier
reaches the first "break-in" level. When the amplifier is turned on, it should operate for
around 4-6 hours.
Turn off procedure
Make sure to turn off the amplifier first when powering down your system.
Note! If the amplifier was turned off even for a short period of time, you should wait
at least 2 minutes before turning it back on. Do not turn it ON then OFF and then ON
again in quick succession.
Follow this procedure each time you turn your amplifier OFF / ON. This precaution will
minimize the stress (high voltages) on internal components.
Vacuum Tube Replacement
The lifetime of vacuum tubes may vary and depends on their operation time and
ambient temperature, playback volume levels and the number of on and off cycles.
Note! The warranty time for vacuum tubes is shorter than for other components of this
device - for more details check your warranty terms or contact a local dealer.
Replacement vacuum tubes are not supplied with this product.
Note! The vacuum tubes are installed inside the device and should be replaced only by
qualified service personnel.
Specifications
Design
Vacuum tubes
Power output
/ impedance
DA converter
Wireless connectivity
Digital inputs
Analog inputs
Analog outputs
14
Hybrid amplifier
Class A/B
Dual Mono
2 x 12AX7-T PSVANE
Treasure Mark II
2 x 200W 8Ω
2 x 400W 4Ω
24bit / 192 kHz
Wolfson WM8805
Cirrus Logic CS4344
Bluetooth® v4.0
Optical, Coaxial
CD, Line
RCA Pre-Out
Headphone output
Impedance: 32-300Ω
Output power: 350mW, 300Ω
Frequency response
20Hz - 35kHz (±0.5dB)
Total Harmonic
≤0.15% (1kHz/ 1W)
Distortions
Signal / Noise ratio
92dB
AC power
230-240V 50Hz, 1200W
/ power consumption
Dimensions
14 x 43 x 44 cm
(H x W x D)
Weight
21 kg / pc.
Bluetooth® is a registered trademark of Bluetooth SIG, Inc.
We reserve the right to change the technical data and the design of the
product without notice as a result of further development.
Need help?
Do you have a question about the HTA-2500B and is the answer not in the manual?
Questions and answers