Error Messages - Furukawa S178 Ver.2 User Manual

Maintenance and Handing Instructions
9. Maintenance and Handling Instructions

9.1. Error Messages

The following is a list of most commonly encountered error messages that can be observed. Refer to the
following table for trouble-shooting.
Error Messages
CUT ERROR
(with side of the failed
fiber)
SPLICE DEFECTS
FEEDING ERROR
(with name of the
failed motor)
OVER-RUN
(with name of the
failed motor)
HEAT TIME OUT
Heater Error No.13
Heater Error No.17
Heater Error No.18
Heater Error No.23
Heater Error No.27
Heater Error No.28
COOL TIME OUT
Error Description
Exceeding the
Cleaving error is inspection criteria for
cleave quality
found in left fiber,
right fiber, or both left Incorrect parameters
and right fibers.
setting for cleave
quality.
See "Splicing Defects,
Fusion Splicing".
The motor does not
Defect in the motor
stop after the time
driving system.
limit from the start.
Fiber is not loaded or
not in the proper
position.
Inappropriate fiber
program is selected.
The motor detected
Bad cleaving quality.
the overrun limit when
running forward.
Defect in the image
processing system.
Defect in the motor
driving system.
V-groove is dirty
The temperature Incorrect parameter is
does not reach the set for heating.
set value within the
time limit from heating Defect in the heating
start up.
system.
Incorrect parameter is
set for heating.
Incorrect parameter is
set for heating.
Voltage decrease
The temperature
does not reach the Incorrect parameter is
set value within the set for heating.
time limit from heating
Incorrect parameter is
start up.
set for heating.
(*)
Incorrect parameter is
set for heating.
Voltage decrease
Incorrect parameter is
set for heating.
The temperature
Incorrect parameter is
does not decrease to
set for cooling.
the set value within
the time limit from
cooling start.
Defect in the heating
system.
Cause of the error
Prepare the fiber
again and retry.
Check and correct the
parameters.
Contact service
center.
Load the fiber at the
proper position.
Check and correct the
program.
Prepare the fiber
again and retry.
Contact service
center.
Contact service
center.
Clean the V-groove.
Check and correct the
parameters.
Contact service
center.
Check and correct the
heating parameters.
Check and correct the
heating parameters.
Recharge the battery.
Use the AC adaptor
Check and correct the
heating parameters.
Check and correct the
heating parameters.
Check and correct the
heating parameters.
Recharge the battery.
Use the AC adaptor
Check and correct the
heating parameters.
Check and correct the
parameters.
Contact service
center.
9-1
Action