Table of Contents
Advertisement
3
General information
Warning!
Risk of injury when used incorrectly!
Prior to the mounting, start-up, and operation of the pressure transducer, it must be en-
sured that the device was correctly chosen with regard to the measuring range, design and
specific measurement conditions. In the event of non-observance, severe personal injury
and/or damage to materials may occur.
Warning!
Risk of injury in the event of insufficient qualifications!
Improper
use
All of the activities described in these operating instructions must only be carried out by
qualified personnel with the qualifications described hereinafter.
Qualified personnel
Due to the specific training and knowledge concerning the measuring and control technology, and due to
their experience and knowledge of the country-specific provisions, standards in force and directives, qualified
personnel are capable of carrying out the described work and of independently identifying the possible risks.
Special employment conditions require further corresponding knowledge, e.g. regarding aggressive media.
Please check, prior to reading the operating instructions, whether or not these instructions cor-
respond to the device. Read these installation and operating instructions carefully prior to any
intervention regarding the METPOINT
all times at the place of application of the device.
If you have any queries regarding these instructions, please contact BEKO TECHNOLOGIES
GMBH.
Installation works must exclusively be carried out by authorised and qualified personnel. Prior to
undertaking any measures, the qualified personnel shall read up on the device by carefully
studying the operating instructions. The operator of the products is responsible for the adher-
ence to these provisions. The respective directives in force apply to the qualification and exper-
tise of the qualified personnel.
For safe operation, the device must only be installed and operated in accordance with the indi-
cations in the operating instructions. In addition, the national and operational statutory provi-
sions and safety regulations, as well as the accident prevention regulations required for the
respective case of application, need to be observed during employment. This applies according-
ly when accessories are used.
®
METPOINT
SP11
can
lead
to
significant
®
PRM. The operating instructions must be accessible at
personal
injury
and
General information
material
damage.
5
Advertisement
Table of Contents
