Transmitter Operation; System Programming - JTECH GuestCall IQ User Manual

Transmitter Operation

®
The GuestCall All in One IQ
ready for use. Pagers will quick charge to full capacity in only two hours.
Default Set-Up

Current time is set

Range test is OFF. Testing range is only necessary for very large properties.

Pagers are set to FLASH & Vibrate when paged.

Duty Alert is OFF

Out of Range alert is OFF
This configuration should be satisfactory for most locations. Should the need arise to make any configuration changes
follow the instructions below. If you have difficulty call our customer service department at 800-321-6221 and a
technician will be happy to walk you through the process.
Paging the Pager
To alert a pager, simply press the pager number on the transmitter keypad followed by the "SEND" key. For example,
press "11 – SEND" and pager #11 will signal. IQ pagers will signal for one minute and then reset. The alert time can be
adjusted via the transmitter. Please see programming instructions below. You can reset any pager by inserting it into a
charger slot.
Locate / All Page Feature
This feature causes ALL pagers (that are not charging) to signal at once. This feature is useful when you are closed and
would like to locate any misplaced pagers around your facility. To locate ALL pagers, press "1249 - SEND". Any pager
not on a charger will signal. Search for the missing pagers by listening for the beep or voice call and looking for flashing
lights. Remember to check the parking lot and look in the bushes! After finding all the missing pagers, put them on a
charger to stop the "locate" alert. Never use the locate feature while pagers are with the guest as all the pagers will
alert at once!!!

System Programming

Enter Programming Mode
1. Press the "SETUP" button.
2. Enter the password "1379" followed by "enter".
3. If the password is accepted, the display will show "Use * to scroll to menu options".
4. Use the "*/Menu" key to scroll through the different menu options.
5. Press "CANCEL" to exit the system programming menu.
800.321.6221
system is plug and play ready. After the proper connections are made, the system will be
User Manual
IQ All in One
Model Number: IQAIO
3