Husqvarna 536LiL Workshop Manual page 27

5. Remove the screws (G) to the control unit and the
screws (H) to the battery connector.
6. Lift out the unit and the fan.
7. Remove the cables (A, gray), (B, black) and (C, red)
from the motor.
8. Remove the cable (D) from the main switch.
9. Remove the connector (E) from the keypad.
10. Remove the connector (F) from the fan.
F
A
B
C
11. For products with S/N: LiL -2015080000
a) Remove the red wire and the connector from the
main switch.
12. For products with S/N: LiR -2015100000
a) Remove the red wire from the battery connector.
737 - 002 - 25.10.2018
G
H
G
H
E
D
b) Hold down the spring (X) with a small
screwdriver to release the pin (Y) and the pull
out the cable.
Y
5.13.1.2 For products with S/N: LiL, LiLX
2015080000-, LiR, LiRX/iRX 201510000-:
1. Remove the operating handle. See
handle on page 37 .
2. Remove the wear guard below the battery housing.
See To remove the wear guard from the battery
housing on page 36 .
3. Remove the battery housing. See
the battery housing on page 37 .
4. Remove the screws (G) to the control unit and the
screws (H) to the battery connector.
5. Lift out the unit and the fan.
6. Remove the cables (A, gray), (B, black) and (C, red)
to the motor.
X
X
Y
Operating
To disassemble
G
H
H
G
Repair instructions - 27