Water Valve - GE GUD27ESSMWW Technical Service Manual
24 and 27 in. unitized laundry centers
Hide thumbs
Also See for GUD27ESSMWW:
- Installation instructions manual (61 pages) ,
- Installation instructions manual (60 pages)
Table of Contents
Advertisement
Water Valve
Each water valve coil has an approximate
resistance value of 1.1k ohm. This can be
measured from the main board J514 connecter
pins 1 to 2 and 1 to 3.
Water Valve Removal
1.
1. Remove the service panel.
2.
3. Although the top cover assembly does not
need to be removed, it has been removed
here for better viewing. (See Top Cover
Assembly in the Washer Components
section of this service guide.)
4. Remove one 1/4-inch hex-head screw
securing the water vale to the bracket.
5. Slide the water valve to the right to drop
through the opening.
6.
funnel hose from the water valve.
– 56 –
Slide Right
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GUD27ESSMWW and is the answer not in the manual?
Questions and answers
How do I clean the Washer? It is starting to smell and there is no clean cycle?
To clean the GE GUD27ESSMWW washer and eliminate odors without a clean cycle, follow these steps:
1. Run a Hot Water Cycle – Fill the washer with hot water and add 1 cup of white vinegar or bleach.
2. Soak and Agitate – Allow the washer to agitate for a few minutes, then pause it and let the solution sit for about 30 minutes.
3. Complete the Cycle – Resume the cycle and let it drain completely.
4. Clean the Drum and Seals – Wipe the inside of the washer drum, door seals, and detergent dispenser with a damp cloth and mild detergent.
5. Leave the Lid Open – After cleaning, keep the washer lid open to air dry and prevent moisture buildup.
Repeat this process monthly or as needed to maintain freshness.
This answer is automatically generated
What is the pin out on a GUD27 control board
I have bamboo sheets and when I dry them on the delicate setting, it leaves black grease marks on the sheets. How do I fix this?
I have a GUD27GSSM2WW stackable GE washer/Dryer. The dryer has power, but the washer doesn't. I think the selector assembly has gone bad. Is there a way to test it with a multimeter?
I ordered tub support dampener got ap-wh1x2727 their too long