Table of Contents
Advertisement
3. Select SETTINGS (A). The SETTINGS page opens.
4. From the GROUP menu (B), select HEADER.
5. From the PARAMETER menu, select LEFT HEIGHT/
TILT SENSOR (A).
6. The SETTINGS page updates to display the voltage in
the VALUE/STATUS field (A). Lower the feeder house
fully, and then raise it 305 mm (12 in.) off the ground to
view the full range of voltage readings.
7. If sensor voltage is not within low and high limits shown
6.1.2 Height Sensor Output Voltage Range –
in
Combine Requirements, page
low and high limits is insufficient, you need to make
adjustments. For instructions, refer to
Height Sensor Voltage Range (Left Side), page 77
Adjusting Header Height Sensor Voltage Range (Right
Side), page
77.
214658
PREDELIVERY INSPECTION
74, or if range between
Adjusting Header
and
81
Figure 6.16: Case IH Combine Display
Figure 6.17: Case IH Combine Display
Figure 6.18: Case IH Combine Display
B
A
A
A
Revision A
Advertisement
Table of Contents
