Clutch Operation; Remote Transmitter Operation; Remote Transmitter Battery Replacement - Badland Winches 63476 Owner's Manual

Operation
Read the ENTIRE IMPORTANT SAFETy INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
The instructions that follow are basic guidelines only and cannot cover all situations encountered
during use. The operator and assistants must carefully plan usage to prevent accidents.

Clutch Operation

1. The position of the pin in the shaft determines
whether the clutch is engaged or not.
Shaft
Pin
Drum
End
Shaft
Pin
Drum
End

Remote Transmitter Operation

Figure G: Remote

Remote Transmitter Battery Replacement

1. Turn Remote Transmitter over.
2. Remove screws from battery cover.
3. Remove battery cover carefully.
Item 63476
If the pin rests
in the groove in the drum
the clutch is engaged.
If the pin rests
on top of the end of the
drum the clutch is released.
For technical questions, please call 1-888-866-5797.
2. To change clutch positions (see Figure F):
a. Pull clutch knob out.
b. Turn it 90° while it is pulled out, then release it.
Figure F: Clutch operation
1. Activate the Remote by pressing the ON/OFF
button for 3 seconds until LED lights up.
2. Press EXTEND or RETRACT to operate winch.
WARNING! Only operate the winch while the
winch, line, and load are in view. Make sure
that there are no bystanders nearby.
3. To turn off the Remote, keep pressing the
ON/OFF button for 3 seconds until LED
turns off. The Remote will automatically
power off in 2 minutes if it is not used.
WARNING! To prevent serious injury from accidental
starting, turn off remote after every use.
4. Pull battery out of unit and replace with same.
Note: Do not reverse polarity of the battery.
a
b
Page 9