Product Description And Specifications; Assembly - Bosch Performance Line CX System Manual

Product Description and
Specifications
Intended Use
y
The drive unit is intended only for driving your eBike and
must not be used for other purposes.
Technical Data
Drive unit
Article number
Rated continuous power
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
m
e
Weight, approx.
Drive unit
Article number
Rated continuous power
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
1)
Bike lights
Voltage, approx.
Maximum output
– Front light
– Rear light
1) Not possible via the eBike battery pack in all country-specific ver-
sions, depending on the statutory regulations
2) The voltage level is preset and can be changed only by the eBike
dealer.
3) When changing the bulbs, ensure that the bulbs are also compatible
with the Bosch eBike system (ask your eBike dealer) and that the spec-
ified voltage matches. Bulbs must be replaced only with bulbs of the
same voltage.
 Incorrectly installed bulbs can be destroyed or cause damage
to the system.
s Bosch eBike Systems
Drive Unit Cruise
0 275 007 065
W
Nm
V
°F
°F
IP 54 (dust and splash
water protected)
lb
Drive Unit CX
0 275 007 038
W
Nm
V
°F
°F
IP 54 (dust and splash
water protected)
lb
2)3)
V
W
W

Assembly

Inserting and removing the battery pack
To insert or remove the battery pack in/from the eBike, please
read and follow the battery pack operating instructions.
Checking the Speed Sensor
250
63
36
+23...+104
+14...+122
8.8
17 Speed sensor
18 Spoke magnet for the speed sensor
250
75
The speed sensor 17 and its spoke magnet 18 must be at-
36
tached in such a way that the spoke magnet, after a turn of
+23...+104
the wheel, moves past the speed sensor with a clearance of
+14...+122
at least 5 mm, yet no more than 17 mm.
Note: If the clearance between the speed sensor 17 and the
spoke magnet 18 is too small or too large, or if the speed sen-
8.8
sor 17 is not properly connected, the speed indicator will fail,
and the eBike drive unit will operate in the emergency mode.
In this case, loosen the screw for the spoke magnet 18 and
6/12
fasten the spoke magnet to the spoke in such a way that it
runs past the mark of the speed sensor at the correct clear-
8.4/17.4
ance. If the speed is still not being indicated on the speed
0.6/0.6
indicator after this is done, please contact an authorized
Bosch eBike dealer.
English–4
17
18
0 275 U07 PDC | (9.5.17)
89