Button Function And Led Light Indication; Actuating Dws By Joining / Separating The Magnet; Definition Of Led Light Indication - Aqara MCCGQ11LM User Manual

Button Function and LED light indication

No Function
1 Join network
2 Reset
3 Check the
network state
Actuating DWS by joining / separating the magnet：
No Function
Send closed
1
message
Send open
2
message

Definition of LED light indication

Operation
Press the reset button for a
short time
Press and hold the reset
button for 3 seconds, until
light blinks, then release it
State
If the DWS is not joined with the network:
Press and Hold the reset button for 3
seconds then the DWS initiates a request to
join the network.
The DWS may or may not be joined to the
network: Press the reset button and the
device will restart.
When the DWS is joined to the network: the
DWS will transmit a data request message,
if the gateway receives the message, it will
ring "ding-dong'
message, otherwise not.
State
After
joining the Bring the magnet within Xmm of the DWS body
network
After
Separate the magnet more than Xmm from the DWS
joining the
body
network
Condition and state
If DWS is not linked to the network
If the joining operation has finished
and succeeded.
If the joining operation has finished
and failed
If the sensor receives a response
from gateway indicating the sensor
was already linked to the network
If the sensor has joined the network or
not, it will disconnect from the
network, and initiate the joining
operation again
after receiving the
Operation
3
Operation
Press and hold the
reset button for
seconds
Press and release the
reset button for a short
time ( <1 second)
Press and release the
reset button for a short
time ( <1 second)
Led indication
LED blinks once quickly
LED blinks 3 times
LED lights up for 1
second
LED blinks twice
Upon successfully
joining the network, the
LED blinks 3 times.
3