Get Started; Install/Replace Microphone Batteries - Philips AEA3100/17 User Manual

3 Get started

Always follow the instructions in this chapter in
sequence.
Connect the wireless
receiver to an existing audio
system
LINE-OUT
1
Connect a 3.5mm audio cable to:
• the LINE-OUT socket on the wireless
receiver.
• the 3.5mm audio input socket on your
existing audio system.
2
Power on the existing audio system and
select the 3.5mm audio input source (see
the user manual of the audio system for
detailed operation).
Install/replace microphone
batteries
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine, or fire. Never discard batteries in fire.
•
Danger of explosion if batteries are incorrectly
replaced. Replace only with the same or equivalent
type.
•
Batteries contain chemical substances, so they should
be disposed of properly.
1
Open the battery compartment and take
out the battery cartridge.
6 EN
MP3 LINK
2
Insert 3 x AAA batteries (supplied) into
the cartridge with correct polarity (+/-) as
indicated.
3
Push back the battery cartridge, then close
the battery compartment.
Note
•
If you are not going to use the microphone for a long
time, remove the batteries.
•
New batteries installed in the microphone support up
to 30 hours of continuous use.
•
When the power indicator flashes red, it indicates that
the power level is low and you need to replace the
batteries.