Restore The Floor Innovo Quick Start Manual

Before You Start
Setting Up The Garments
• Choose your gel pad
4
position (either A or B).
B
Hip Circumference Size A or B
86.3–97.5cm (34–38.4") S A
97.6–107.7cm (38.5–42.4") S B
107.9–116.6cm (42.5–45.9") M A
116.8–121.7cm (46–47.9") M B
121.9–124.6cm (48–49") L A
124.7–127cm (49–50") L B
Put On The Right Garment
8
• From the outer side, place the
tips of your fingers of your
right hand into the slit. Place
your left index finger in the
small hole as shown. Lift the
garment with gel pads
facing your body.
Put On The Left Garment
10
• Pick up the left garment by
placing the tips of your fingers
of your left hand into the slit.
Place your right index finger in
the small hole as shown. Lift the
garment with gel pads facing
your body. Then put on the
garment as per steps 11 a-e.
Before Using Innovo
• Connect the red
13
end of the lead
to the red pin on
the garment and
the blue end to
the blue pin.
Important: Make sure both connectors are
pushed firmly into place.
Using The Controller
16
• When in position,
turn on the
controller by
pressing the
P i
power button.
During And After Your Session
0
19
20
30
• You can use the neck
strap during the
treatment, which will
take 30 minutes.
Innovo from Atlantic Therapeutics, Designed by & manufactured for Bio-Medical Research Ltd., Parkmore Business Park West, Galway, Ireland.
QUICK START GUIDE
1
2
a
b
• Unpack The
Contents
c
5
A
• Remove liners from the grid
patterned side of the gel pads.
a
9
a
11
• Connect the lead to
14
17
• Press the +
button to
increase the
i
P
intensity.
• Press the on/off
21
button for 2
seconds to switch
the unit off after
your session.
i
P
• Your battery will take
5 hours to fully charge
• Have you read the manual
and watched the video
on restorethefloor.com?
• Are you wearing underwear
that exposes the buttocks?
6 7
• Apply 4 gel pads to each garment
by pressing firmly on each one.
b
• Guide your right • Wrap the
finger tips to garment
the crease of around your
your buttocks leg guiding
and press the your left
garment onto index finger
your skin. to the bikini
line...
b c
15
the controller. You
may need to slide
the doors open.
• At first you should increase the intensity to
18
30 -40, to start feeling the pelvic floor
contracting. You will know your pelvic floor
is contracting when the sensation shifts
from the bottom muscles slightly forward
so that it can be felt both in the bottom and
between the legs. You should feel little or no
activity on the front and sides of the legs.
As you become familiar with the sensation
you should increase the intensity level over
time to reach the optimum level of 70 - 75.
• Disconnect the lead from
the controller and
garments. Remove
garments by unfastening
and carefully peeling from
the body. Leave the gel
pads on the garments.
www.restorethefloor.com
UK: Freephone 0800 0285687
IRL: Freephone 1800 800045
INT: +353 1 9075393
3
7
• Remove liners from black side.
Keep them as you will need
them later.
c d
• ...then wrap
the strap
around
inside your
leg and back
of thigh...
d e
12
• Your garments
should look like
this when
correctly
postioned on
the body.
• Choose whether you will
Pelvic floor muscles
support the bladder,
uterus and rectum
• Lay both garments
22
flat and replace
the liners.
ENGLISH
• Lay both garments
on a flat surface.
e
• ...and fasten the
garment securely.
carry out your session in
the standing, reclining or
lying position. Refer to
your instruction manual for
more information.
Knees
Must Be
Bent
23
• Fold the garments in
half to ensure the gel
pads remain flat when
packed away.
Part No.: 2490-0803 - Rev.: 1 - Issue date: 10/15