Configuring Locator ID Separation Protocol
Configuring Locator/ID Separation Protocol
Enabling the LISP Feature
You can enable the LISP feature on the Cisco NX-OS device.
Procedure
Step 1
Step 2
Configuring LISP ITR/ETR (xTR) Functionality
Configuring LISP ITR/ETR (xTR)
You can enable and configure a LISP xTR with a LISP Map-Server and Map-Resolver for mapping services
for both IPv4 and IPv6 address families.
Procedure
Step 1
Step 2
Step 3
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
feature lisp
Example:
switch(config)# feature lisp
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
{ip | ipv6} lisp itr
Example:
switch(config)# ip lisp itr
Example:
switch(config)# ipv6 lisp itr
{ip | ipv6} lisp etr
Example:
switch(config)# ip lisp etr
Configuring Locator/ID Separation Protocol
Purpose
Enters global configuration mode.
Enables the LISP feature set if it is not already
configured.
Purpose
Enters global configuration mode.
Enables LISP ITR functionality.
Enables LISP ETR functionality.
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
7