Kinetico K5 Troubleshooting Manual
Drinking water station
Hide thumbs
Also See for K5:
- Manual (61 pages) ,
- Owner's manual (24 pages) ,
- Installation instructions (4 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Kinetico K5
Summary of Contents for Kinetico K5
- Page 1 K5 Drinking Water Station Trouble Shooting Guide...
- Page 2 ** System must meet a minimum feed pressure of 35 psi 100 ppm TDS = 1 psi of osmotic pressure 1000 ppm TDS = 10 psi osmotic pressure Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 2 of 7...
- Page 3 K5 Drinking Water Station Trouble Shooting Guide Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 3 of 7...
- Page 4 K5 Drinking Water Station Trouble Shooting Guide Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 4 of 7...
- Page 5 K5 Drinking Water Station Trouble Shooting Guide Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 5 of 7...
- Page 6 K5 Drinking Water Station Trouble Shooting Guide Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 6 of 7...
- Page 7 K5 Drinking Water Station Trouble Shooting Guide Kinetico Incorporated 10845 Kinsman Road, Newbury, OH 44065 440/564-9111 Product No. 14337 Revision 12/2010 Page 7 of 7...
Need help?
Do you have a question about the K5 and is the answer not in the manual?
Questions and answers
water leaking from the top of the K5 water station
The water is leaking from the top of the Kinetico K5 water station due to small holes in the pump housing on top of the unit. This issue was identified in an older version of the system. A new version of the manifold has been introduced with a built-in drain line to prevent future leaks, and the small holes have been removed.
This answer is automatically generated
Replaced filters in K5 filtration system, but no water is flowing to my faucet. How do I purge the air from the system?
To purge air from the Kinetico K5 filtration system after replacing the filters, follow these steps:
1. Ensure the water supply to the unit is turned back on.
2. Slowly open the K5’s dedicated tap.
3. Let the water flow from the faucet. It may sputter due to air in the lines.
4. Allow the water to run until the stream stops.
5. Wait several minutes for the system to produce more water and fill the storage tank.
6. Repeat the flushing process a second time before consuming the water.
This ensures the system is properly flushed and air is removed.
This answer is automatically generated
Water turned off to K5 system under the sink. How do I turn water back on to the system?