First Alert 5200DF Owner's Manual page 3

Programming A Personal Passcode
PROGRAMMING A PERSONAL PASSCODE
Press the red reset button located on
1
the inside of the safe (you may need a
small apparatus). The red light will blink
continuously.
Enter your new 4-8 digit passcode and
2
press the red reset button. The green
light will blink continuously.
Reenter your new passcode and press the red reset button.
3
If both entries match, the green light will turn on for 2 seconds and a new
4
passcode is set for operation.
If both entries do not match, the red light will turn on for 2 seconds and revert
5
back to the previous passcode for operation.
Record your new passcode in the Safe Identification Record
6
on page 5.
ONCE YOUR PERSONAL PASSCODE IS PROGRAMMED, THE
IMPORTANT
FACTORY PRE-SET CODE WILL NO LONGER OPEN THE SAFE.
SECURITY LOCKOUT PERIODS
a If an invalid passcode has been entered, the red light will blink
continously.
a For added security, the safe will automatically lock out for 4
minutes after several attempts to open the safe with an invalid
passcode.
a If you forget your personal passcode, access to the safe can be
made using the emergency override key.
SECURING THE CABLE TO YOUR SAFE
Wrap the cable around a fixed object.
1
Loop one end of the cable through
2
the other and tighten around the fixed object.
Place the loose end of the cable in the notch
3
located on the side of the case.
Close the lid and lock the case.
4
3
Reset Button
!
4
MINUTES
SAFE CARE AND MAINTENANCE
When properly maintained, your safe will continue to operate accurately for many
years. In order to ensure optimum performance of your safe, please follow these
simple precautions:
BATTERY MAINTENANCE
Always purchase and use the batteries as specified by this User's manual.
1
Always replace all batteries at the same time. It is recommended to replace all
2
batteries at least once a year or sooner depending on amount of use.
Always clean the battery contacts in the battery compartment and on the
3
batteries before installing new batteries.
Always make sure all batteries match the polarity (+ and -) signs in the open
4
battery compartment.
If your safe will not be used for an extended period of time, it is recommended
5
that you remove the batteries.
Always promptly remove and properly discard of all used batteries.
6
CLEAN HANDS
Never attempt to operate the digital keypad if your hands have excessive dirt, debris
or liquids on them.
CLEAN SAFE
To clean the surface of your safe, it is recommended that you use a mild cleaner
(e.g., window cleaner) to avoid scratching or discoloring the surface. Always wipe
dry and NEVER use abrasive cleansers on the safe or digital keypad.
For future reference, store this manual in a secure area away from the safe.
DO NOT DISCARD!
NOTE: STORE KEYS IN A SECURE PLACE AWAY FROM CHILDREN.
NEVER PLACE THE KEYS INSIDE THE SAFE.
Safe Care and Maintenance
4