Program The Keypad - Mighty Mule MMKPD Instruction For The Installation

Program the Keypad

• A Master Code is needed to add, remove, or program Entry Codes.
• Factory default Master Code is "1234."
• Keypad can only enter "program" mode from "idle" mode.
• Keypad will beep three times before going into "idle" mode
(more than 10 seconds between key presses).
Programming Confirmed: Keypad will beep 3 times.
Error Message: Status light will flash rapidly, error tone will sound for
1 second and keypad will return to "idle" mode (changes not saved).
• Entry Code is not 4 digits.
• New Master Codes don't match ("Program New Master Code").
• Memory is full (already 25 codes).
• No matching code is found ("Delete Entry Code").
Program New Master Code
1. Press and Release Program Button:
2. Enter current Master Code:
(example: the factory default Master Code)
3. Press and Release Program Button:
4. Enter the Function Code:
5. Press and Release Program Button:
6. Enter the new Master Code:
7. Press and Release Program Button:
8. Enter the new Master Code again:
9. Press and Release Program Button:
Add Temporary Entry Code
*In step 4, you will need to enter a number from 1 through 7
to indicate the number of days until the Entry Code expires.
1.
2.
3.
8
4.
Function Code & # of days Code will be active*
5.
6.
7.
4
1
0
Master Code
Temporary Entry Code
= Your 4-digit code.
Add New Entry Code
1.
2.
2 3 4
3.
0
4.
6
5.
6.
7.
Delete Entry Code
1.
2.
3.
0
4.
5.
6.
7.
Delete All Entry Codes
1.
2.
3.
0
4.
5.
1 2
4 5
7 8
0
Program Button
Master Code
2
Function Code
New Entry Code
Master Code
3
Function Code
Code to be deleted
Master Code
7
Function Code
3
6
9
Status Light