Setting Up The Avhc10 In Mach3 - PRICECNC AVHC10 Installation And Operation Manual

2.7.1 Setting up the AVHC10 in Mach3

1. From the Menu Bar in Mach3, click on 'Config' > 'Ports and Pins' > 'Input Signals'.
2. Scroll down the Signals list and change the setting for 'THC On', 'THC Up' and 'THC
Down' to the correct Port and Pin Number.
Note: The 'Probe' signal is for the floating Z-axis and responds to G31 commands.
3. Click on the 'Output Signals' tab. Change the setting for 'Output #2' to the pin that will
operate the AVHC10 anti-dive.
Note: A different output number can be selected from the signal list. 'Output #2' is turned
on by the G-code command 'M11P2' and turned off by 'M10P2' If a different output
number is required, change the '2' in the code snippet to the required number when
creating the rules in SheetCam. For details, see section 5.
13