Page 2
TAblE Of cOnTEnTS TorqueMaster Plus Replacement Spring Components ® TorqueMaster ® Plus End Bracket identification ..Tools Needed ............. Single And Double Spring TorqueMaster Plus Removal ® TorqueMaster Plus Single And Double Spring Replacement ® TORQUEMASTER PlUS REPlAcEMEnT SPRing cOMPOnEnTS fOR ®...
Page 3
Drum Single and Double Spring TorqueMaster Plus Removal ® Wrap Cable iMPORTAnT! Right and left hand is always determined from inside the Drum Drum building looking out. Wrap wARning Cable Drum COuNTERBALANCE SPRiNG TENSiON MuST BE RELiEVED BEFORE REMOViNG ANY HARDWARE. A POWERFuL SPRiNG RELEASiNG iTS ENERGY SuDDENLY CAN CAuSE SEVERE iNjuRY.
Page 4
End Bracket Single and Double Spring TorqueMaster Plus Removal ® End Bracket - Continued nOTE: Spring(s) are fully unwound when counterbalance cables have no tension. STEP 3: Us e th es th is e Illu lab el. str at ion , in co Standard lift/front Mount low Headroom Applications: nju nc...
Page 5
Right Hand TorqueMaster Plus Single and Double Spring Replacement ® Spring Perch iMPORTAnT! RiGHT AND LEFT HAND iS ALWAYS DETERMiNED FROM iNSiDE THE BuiLDiNG LOOkiNG OuT. TorqueMaster ® Slide the new spring(s), perch end first, into the torque tube (each spring is Tube identified as to right and left hand, on the perch), as shown in fig.
Page 6
TorqueMaster Plus Single and Double Spring Replacement ® Splines - Continued Groove Winding Shaft iMPORTAnT: WARNiNG TAGS MuST BE SECuRELY ATTACHED TO BOTH END BRACkETS, AS SHOWN iN fig. 3.1. End brackets are right and left hand. You can identify the right hand end bracket by the disconnect cable guide hole in the top of the bracket.
Page 7
TorqueMaster Plus Single and Double Spring Replacement ® Splines Disconnect - Continued Winding Cable Guide Hole Shaft wARning Right End Bracket iT iS RECOMMENDED THAT LEATHER GLOVES BE WORN Groove WHiLE WiNDiNG THE TORquEMASTER PLuS SPRiNGS. ® FAiLuRE TO WEAR GLOVES MAY CAuSE iNjuRY TO Warning HANDS.
Page 8
REcOMMEndEd TorqueMaster Plus Single and Double Spring Replacement ® SPRing TURnS - Continued door Ratchet Spring Turns Height End Bracket Now, lift door and check it’s balance. if door raises off the floor under spring tension alone, then reduce spring tension until door rest on the floor. if the 5/8”...
Need help?
Do you have a question about the Torquemaster Plus and is the answer not in the manual?
Questions and answers