TERMA Alex ONE Installation Manual

Installation guide Alex ONE 1140x500mm - E8
Please read the instructions in full before starting to fit your radiator.
• Please check that all parts listed are present before starting installa-
tion.
• Valves are not provided, please make sure that you have them
before you start. This product requires standard 1/2" radiator valves.
• Before drilling holes for the brackets please check that there are no
hidden wires or pipes.
• The plugs supplied are for hard walls masonry only. Please make
sure you are using the correct plug for your wall.
• Terma radiators are designed for closed heating systems.
• The radiator should be fitted at least 100 mm from the floor to
maximise heat efficiency.
• Noting the distances between bracket centres, mark out the
position of the brackets on the wall.
• Drill holes to approximately 80 mm depth using a 10 mm drill bit
and insert rawl plugs (1). Using connecting screw with a washer (2)
attach mounting bracket-1 (3).
• Guide radiator brackets into mounting brackets - 1(3) and fix with
connecting screws (4)
• Connect the water flow using appropriate 1/2" BSP valves. Follow
valves manufacture guidelines for correct installation.
• Fill the radiator and purge any trapped air via the bleed valve at the
top of the radiator.
• Wipe your radiator down using a clean damp cloth.
Never use scourers or abrasives.
For all installation and warranty enquiries please
contact Crimson Bear Customer Support on
01535 636256
ON/OFF
E8
500
130 470
30

Fixing kit content

rawl plug (1)
wall fixing (2)
screw +
washer
mounting (3)
bracket-1
bracket to (4)
collector
fixing screw
air vent
allen key
Refers to water and dual fuel version