Function Messages; Error Messages - Worx Landroid WR142E Owner's Manual

10. Function Messages

Cutting grass
Raining
Going home
Charging
No working time scheduled
Not working today
Work done today
Searching working area
Charging 100%
Emergency charging

11. Error Messages

Message
Machine can't find
Outside working
boundary wire signal
area! Press
or the direction of
"START" to reset
boundary is wrong.
Please enter right
PIN code is wrong.
PIN code
Blade motor fault!
Press "START" to Blade disc is blocked.
reset
Wheels motor fault!
Wheel motor is
Press "START" to
blocked.
reset
Owner's Manual
cutting grass according to the program setting
The rain sensor detects water. Landroid
and stay there for the time you have programmed it to do so. When dry,
®
Landroid will automatically begin the delay and countdown and then
return to mow. If you want Landroid
then on again, but only when the rain sensor is dry or you can set the delay
time to 0 min.
needs to recharge—during the journey to the base, the cutting blade is
stopped in order to save energy
charge is in progress—charge percentage are displayed
stand-by, need to be programmed as desired.
stand-by, will start according to program set.
According to the setting of "Customize work zone" , Landroid
a certain area to mow.
®
Landroid has completed its charging.
®
Landroid is charging in power-off state.
Cause
1. If Landroid
inside its territory. Turn power on. Press
2. If the Landroid
is green. If not, verify that the charging base is properly connected to the
charger and that the charger is connected to a suitable power supply. If they are
properly connected, the boundary wires are clamped incorrectly and must be
reversed.
3. Reverse the boundary wire ends.
Input the correct PIN or re-set your PIN.
1. Turn power off;
2. Turn Landroid
blade disc to rotate.
3. Remove any obstruction.
4.Turn Landroid
cutting height;
5. Turn power on. Press
1.Turn power off; take Landroid
2. Turn power on. Press
3. If the error message is still displayed; turn power off; turn Landroid
upside-down and check if there's anything preventing the wheels from
rotating.
4. Remove any obstruction, turn Landroid
®
®
to mow before this, simply turn it off
Action
®
is actually outside its territory: turn power off, take Landroid
®
is inside its territory, check if the LED on the charging base
®
upside down and check if there's anything preventing the
®
upright and take it to an area with short grass or adjust the
.
®
in an area free from obstacles;
.
will return to the charging base
®
is searching
.
®
®
upright, turn power on.
EN
21
®