Advertisement
Quick Links
750 Series II
CONDUCTIVITY/TDS
RESISTIVITY
MONITOR/CONTROLLER
Operation
INSTALLATION • OPERATION • MAINTENANCE
Conductivity/TDS Models: 756II, 757II, 758II & 759II
Resistivity Models: 751II, 752II, 753II & 754II
ACCURACY • RELIABILITY • SIMPLICITY
&
Manual
22 October 08
Water Quality Instrumentation
Accuracy • Reliability • Simplicity
Advertisement
Related Manuals for Myron L 758II-121-SC
Summary of Contents for Myron L 758II-121-SC
- Page 1 750 Series II CONDUCTIVITY/TDS & RESISTIVITY MONITOR/CONTROLLER Operation Manual 22 October 08 INSTALLATION • OPERATION • MAINTENANCE Conductivity/TDS Models: 756II, 757II, 758II & 759II Resistivity Models: 751II, 752II, 753II & 754II ACCURACY • RELIABILITY • SIMPLICITY Water Quality Instrumentation Accuracy • Reliability • Simplicity...
- Page 2 MICROSIEMENS / CM 750II HIGH SET POINT 750 Series II Model 758 -121-SC (A Digital Conductivity Monitor/controller, with a Range of 0-2000 µS, and a Second Alarm/control, Displaying Full Scale)
- Page 3 “115/230 VAC” SELECTION IS CORRECT FOR YOUR operation of each option. REQUIREMENTS. FAILURE TO DO SO IS BEYOND THE RESPONSIBILITY OF THE MYRON L COMPANY. QUICK LOCATOR See section II.E.2. and figure II.E.1. SC/SCO MODULE, (Second Relay), see section III.A.
- Page 4 See Section IV.C.4. calibration of resistivity models is to use the transfer standard method, using a hand-held or portable instrument capable of resistivity measurements, i.e. the Myron L Ultrameter II™. See PRIMARY COMPONENT IDENTIFICATION - section V.C.4 for description. Section V.A.
-
Page 5: Warranty
A reasonable service charge will be made for diagnosis or repairs due to normal wear, abuse or tampering. Warranty is limited to the repair or replacement of Monitor/controller or sensor only. The Myron L Company assumes no other responsibility or liability.
Need help?
Do you have a question about the 758II-121-SC and is the answer not in the manual?
Questions and answers