Ronbow AMORA VANITY 054030 Installation And Care Manual page 8

AMORA
Vanity
Model :
054030
INSTALL THE VANITY TOP
Step 1:
Clean the surface of the cabinet with a
damp cloth.
Step 2:
Install the sink to the vanity top per
the manufacturer's instructions.
Step 3:
Apply a thin bead of silicone to the
surface of the vanity.
Carefully place the vanity top on
the vanity.
Clean o any excess
silicone immediately.
See Figure 13.
Step 4:
Follow the directions on the silicone
tube to allow for ample drying time.
Refrain from moving/using the
vanity during this time.
REINSTALL CENTER DRAWER
Step1:
When the plumbing is finished, clip the
hinges back on. There are small hooks on
the bottom of the hinge (see below, left)
that catch on the plate attached to the
vanity. Align these, then press down on
the back of the hinges until you hear
a click.
See Figure 14
INSTALLATION SHEET
Figure 13.
NOTE:
For WideAppeal™ Countertops:
WideAppeal™ Countertops include
a wooden inner frame. To prep the
countertop for installation, first
apply a thin bead of silicone to the
inner frame, then attach the frame
to the countertop.
Please note: a 1/2" gap between the
vanity top and the vanity is an
intentional part of the design and is
not a defect.
See Figure 14
ronbow.com
Cup
7
170405